Abstract:This work presents the spatio-temporal variations of microcracking and damage accumulation during the progressive failure in a low-porosity sandstone under uniaxial compression, using active ultrasonic surveys and passive acoustic emission monitoring. The combination of both techniques allows us to perform a joint inversion of source locations and P-wave velocity tomography of the specimen during the failure process. Based on the P-wave first arrivals from both the active surveys and numerous passive AE events, three-dimensional (3D) P-wave velocity structure and its temporal variations can be obtained in high resolution in spite of the limited active ray coverage. The reconstructed P-wave velocity structure indicates that the specimen becomes more heterogeneous due to damage accumulation. Within such a highly anisotropic medium, the ray paths are found to be curved, rather than straight as assumed in a homogeneous material. The curved ray paths are used to calculate the travel times of each AE event so as to obtain the accurate source location. We calculate the energy of the detected AE event and estimate the energy distribution. It shows that about 50% of the events account only for about 2.5% of the total energy while 1% of the events release 47.3% of the total energy. The events with large energy, albeit few, allow to trace the fractures. We also investigate the variations of the P-wave velocities along different characteristic ray paths during the failure process. Based on the joint inversion, the variations of the 3D P-wave velocity structure with deformation have been further investigated. It is found that the emergence of the low-velocity zone (LVZ) does not indicate the onset of fractures and that the LVZ is highly unpredictable in a spatio-temporal sense. The spatial correlation between the LVZ and AE events suggests that AE events usually appear on the edge of the LVZs, where there are high-velocity contrasts. This work suggests that the quantification of P-wave velocity changes has the potential for extracting timely precursory information of pillar bursts.

Study on Failure Mechanism of Tight Sandstone Based on Moment Tensor Inversion

Fracture mechanism of tight sandstone under high and complex 3-D stress compression: Insights from acoustic emission

Pre-peak acoustic emission characteristics of tight sandstone failure under true triaxial stress

Study on the AE Characteristics and Energy Evolution Mechanism of Sandstone with Different Aspect Ratios Under Biaxial Compression

Failure mechanism of fractured rock and associated acoustic behaviors under different loading rates

Experimental Study on Mechanical Behavior, Fracture Characteristics, and Acoustic Emission Damage Characteristics of Sandstone Under Triaxial Multistage Stress Disturbance

Effects of confining pressure on acoustic emission and failure characteristics of sandstone

Shear Failure Mechanisms of Sandstone Subjected to Direct, True Triaxial and Confining Shear Test Conditions

Acoustic Emission Associated with Self-Sustaining Failure in Low-Porosity Sandstone under Uniaxial Compression

Investigating the Mechanical Deterioration Effect of Hard Sandstone Induced by Layer Structure under Uniaxial Compression

Experimental research on the mechanical and acoustic emission properties of layered sandstone during tensile failure

Investigation of the crack and acoustic emission behavior evolution of red sandstone subjected to water

Study on the Evolution of Mechanical Properties and Acoustic Emission of Medium-Permeability Sandstone under Multi-Level Cyclic Loading Stress Paths

Laboratory Shear Behavior of Tensile- and Shear-Induced Fractures in Sandstone: Insights from Acoustic Emission

Assessment on anisotropy degree and fracture modes for weakly anisotropic sandstone using the acoustic emission technique

Study on mechanical properties and microscopic damage mechanism of tight sandstone reservoir under uniaxial compression

Study on the mechanism of energy evolution and bearing degradation in pre-cracked sandstone under non uniform cyclic loading

Acoustic Emissions and Seismic Tomography of Sandstone under Uniaxial Compression: Implications for the Progressive Failure in Pillars

Strength and acoustic emission weakening mechanism of sandstone after prolonged water immersion: Insights from micro-fracture

Study on Hydro-Mechanical Coupling Failure and Permeability Enhancement Mechanisms for Sandstone with T-Shaped Fractures

Experimental investigation of microscopic crack development and damage characteristics of sandstone based on acoustic emission characteristic parameters