Abstract:In order to study the prevention of roadway roof bending, sinking, and breaking and the prevention of dynamic disasters such as the appearance of rock bursts, three-point bending experiments of sandstone under different spans were carried out. By using stress loading system and acoustic emission technology, the acoustic emission characteristic parameters of the sandstone fracture process were analyzed, the precursory information of rock bending fracture was explored, and the evolution law of sandstone damage based on acoustic emission characteristics was obtained. The results showed that according to the variation of acoustic emission ringing count, the load-time curve was divided into four typical stages: the first stage showed an overall increasing trend; the second stage showed an obvious increasing trend; the third stage showed obvious accelerated growth and the acoustic emission ringing count reached the maximum at the moment of rupture. In the fourth stage, the amplitude and frequency of the ringing count are large and high. With the increase in span, the cumulative ringing counts of AE decreased, and the rate of change gradually decreased. The fracture process of three-point bending sandstone can reflect the precursor information of rock fracture from time domain, frequency domain, and R value (ratio of cumulative acoustic emission ringing count to cumulative energy count). In time domain, the evolution characteristics of AE cumulative ringing count stage II can be used to predict the three-point bending fracture of sandstone. The peak frequency shows a linear increase after a spike and then an accelerated increase to a rupture, and the boundary point between the spike and the linear and nonlinear can be obtained. The decrease in R value can indicate that the main crack is growing in the specimen. According to the damage rate, the characteristics of the damage variables can be divided into five stages: stationary and low, gradually increasing, gradually decreasing, main crack coalescence, and complete fracture. With the increase in span, the fracture damage shows a decreasing trend. The residual damage fluctuates between 0.38 and 0.40 due to the difference in crack propagation trajectory. It has theoretical research value for revealing the internal mechanism of rock bending and fracture and has engineering guiding significance for mine pressure and rock strata control and dynamic disaster prevention.

Study on the AE Characteristics and Energy Evolution Mechanism of Sandstone with Different Aspect Ratios Under Biaxial Compression

Analysis of Acoustic Emission Energy Distribution and Avalanche Dynamics of Sandstone with Different Particle Sizes

Study on the mechanism of energy evolution and bearing degradation in pre-cracked sandstone under non uniform cyclic loading

An experimental study of Lode angle impact on the rock failure procession based on acoustic emission

Effects of confining pressure on acoustic emission and failure characteristics of sandstone

Study on Acoustic Emission and Crack Propagation Characteristics of Single-Fissured Sandstone with Different Angles Under Uniaxial Compression

Response characteristics of acoustic emission signal and judgment criteria for different fracture modes

Stress-induced AE varying characteristics in distinct lithologies subjected to uniaxial compression

Investigation of the crack and acoustic emission behavior evolution of red sandstone subjected to water

Influence of Inclination Angle on the Acoustic Emission Characteristics of Pre-Cracked Sandstone in Uniaxial Arc Cyclic Loading and Unloading Tests

Effect of water content on the failure pattern and acoustic emission characteristics of red sandstone

Mechanical Behavior and Acoustic Emission Characteristics of Sandstone Under Different Cyclic Loading and Unloading Disturbance Rates

Uniaxial Compressive Failure Characteristics and Fractal Analysis of Mud–Sand Composite Rock Samples Based on Acoustic Emission Tests

Experimental Study on Acoustic Emission Features and Energy Dissipation Properties during Rock Shear-Slip Process

Investigating the Mechanical Deterioration Effect of Hard Sandstone Induced by Layer Structure under Uniaxial Compression

Study on Acoustic Emission Characteristics and Damage Evolution Law of Shale under Uniaxial Compression

Experiment Study on the Mechanical Behavior and Acoustic Emission Response of Thick and Hard Sandstone Roof in Xinjiang Mining Area

Acoustic Emission Characteristics and Energy Evolution of Red Sandstone Samples under Cyclic Loading and Unloading

Acoustic Emission Characteristics and Damage Evolution Analysis of Sandstone under Three-Point Bending Test

Critical slowing down characteristics of acoustic emission for fracture instability of sandstone down-slope rock bridge under cyclic wetting and drying

Acoustic emission characteristics and fracture mechanism of sandstone in open-pit mines under different types of cyclic loads