Investigation of the effect of ultrasonic micro-welding process parameters on the microstructure components bonding
Mehrzad Modarres,Mohammad Tahmasebipour
DOI: https://doi.org/10.1007/s40430-022-03614-8
IF: 2.361
2022-07-09
Journal of the Brazilian Society of Mechanical Sciences and Engineering
Abstract:In this paper, the application of the ultrasonic micro-welding process has been presented for bonding the microstructures. Two sheets made of the PMMA (including a micro-channel, inlet, and outlet) were connected by applying the ultrasonic waves with 20 kHz frequency and 2000-W power. The effects of the important parameters of the ultrasonic micro-welding process including energy directors (EDs) height (300, 450, and 600 micrometers), applied pressure (2, 2.5, and 3 bar) and time (0.1, 0.2, and 0.3 s) have been investigated on the distribution of the generated temperature during the ultrasonic welding process, affected areas by the ultrasonic welding as well as compressive-shear strength of the samples. In this study, the Taguchi method has been used to achieve the optimal levels of the mentioned parameters by analysis of the signal-to-noise ( S / N ) ratios, and the order of importance of the process parameters was specified by using the analysis of variance of the S / N ratios. The optimal levels of the parameters of the micro-welding process were determined as EDs height of 300 μm, applied pressure of 3 bar, and process time of 0.1 s. The amount of max. temperature, welding area, and max. compressive-shear strength obtained for optimal levels of the process parameters was assessed as 398 K, 15.17 mm 2 , and 5.2e13 Pa, respectively.
engineering, mechanical