Abstract:A wideband low-noise amplifier (LNA) featuring transformer-based wideband input matching is proposed for millimeter-wave applications. By analyzing the properties of conventional series input matching networks, which were widely employed in narrowband LNAs and shunt-series matching networks for bandwidth extension, a novel input matching network possessing the merits of both was proposed. For further bandwidth extension, another peak of input impedance at a higher frequency is introduced for the proposed input matching network. Moreover, it is proved that the proposed input matching network can suppress the gate resistor noise, resulting in significant noise figure (NF) improvement of an LNA. On the other hand, the NF is further reduced by connecting a transformer between the two amplification stages, which helps suppress the noise contribution from the second stage, leading to an LNA design with NF lower than 4.5 dB over a very wide operating bandwidth. To enhance the gain bandwidth, the peak distribution, including both shunt peaking and series peaking, is discussed. By appropriately distributing these peaks, which is also known as the pole-tuning technique, a wider gain bandwidth can be obtained. To validate the proposed techniques, an LNA with two common-source (CS) stages is designed and fabricated using a 65-nm CMOS process, and the overall chip size, including all pads, is only 0.26 mm². The two CS stages are cascoded for dc biasing to reduce the power consumption. Experimental results show that a peak gain of 13.5 dB is achieved within a -3-dB bandwidth from 19.2 to 42.6 GHz. The measured NF is 3.1-4.5 dB, and the input 1-dB gain compression point (IP1 dB) ranges from -13.54 to -9.89 dBm in the entire gain bandwidth. The input return loss S₁₁ is less than -10 dB over a frequency range of 16.8-38.9 GHz. Moreover, benefiting from the current-reuse technique, the power consumption of the LNA is only 6.36-mW.

A Capacitor Assisting Triple-Winding Transformer Low-Noise Amplifier with 0.8-1.5Db NF $6-12\Text{ghz BW} \pm 0.75\text{db}$ Ripple in 130nm SOI CMOS

A Capacitor Assisting Triple-Winding Transformer Low-Noise Amplifier with 0.8-1.5dB NF 6-12GHz BW 0.75dB Ripple in 130nm SOI CMOS

A 6–12 GHz Wideband Low-Noise Amplifier with 0.8–1.5 Db NF and ±0.75 Db Ripple Enabled by the Capacitor Assisting Triple-Winding Transformer

0.9–10GHz low noise amplifier with capacitive cross coupling

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

Ultralow Power E-Band Low-Noise Amplifier with Three-Stacked Current-Sharing Amplification Stages in 28-Nm CMOS

Compact 50-62 GHz Current-Reused Low-Noise Amplifier with Gate-Drain Transformer Feedback

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

A 10‐mw 3.9‐db NF Transformer‐based V‐band Low‐noise Amplifier in 65‐nm CMOS

A 54.4–90 GHz Low-Noise Amplifier in 65-nm CMOS

A Q-band CMOS LNA Exploiting Transformer Feedback and Noise-Cancelling

Ultralow Noise Figure and Broadband CMOS LNA With Three-Winding Transformer and Large Transistor

A Capacitor Cross-Coupled Common-Gate Low-Noise Amplifier

A Compact 0.2-1.6 GHz 20 MHz-Bandwidth Passive-LNA Exploiting an N-Path 1:3 Transformer

A 3.4 Db Nf K-Band Lna with A Tapped Capacitor Matching Network in 65 Nm Cmos Technology

A 0.03-3Ghz Inductorless Wideband Low Noise Amplifier in 65nm CMOS

A Wideband CMOS LNA Using Transformer-Based Input Matching and Pole-Tuning Technique

28 GHz Compact LNAs with 1.9 Db NF Using Folded Three-Coil Transformer and Dual-Feedforward Techniques in 65nm CMOS

A 0.9/1.8/2.4Ghz-Reconfigurable LNA with Inductor and Capacitor Tuning for IoT Application in 65nm CMOS

A Q-band CMOS LNA with noise cancellation