Abstract:A wideband common-gate (CG) low-noise amplifier (LNA) with dual capacitor cross-coupled (CCC) feedback and negative impedance techniques is presented for multimode multiband wireless communication applications. Double CCC technique boosts the input transconductance of the LNA, and low power consumption is obtained by using current-reuse technique. Negative impedance technique is employed to alleviate the correlation between the transconductance of the matching transistors and input impedance. Meanwhile, it also allows us to achieve a lower noise figure (NF). Moreover, current bleeding technique is adopted to allow the choice of a larger load resistor without sacrificing the voltage headroom. The proposed architecture achieves low noise, low power and high gain simultaneously without the use of bulky inductors. Simulation results of a 0.18-μm CMOS implementation show that the proposed LNA provides a maximum voltage gain of 25.02dB and a minimum NF of 2.37dB from 0.1 to 2.25GHz. The input-referred third-order intercept point (IIP3) and input 1-dB compression point (IP1dB) are better than –7.8dBm and –19.2dBm, respectively, across the operating bandwidth. The circuit dissipates 3.24mW from 1.8V DC supply with an active area of 0.03mm2.

A Capacitor Cross-Coupled Common-Gate Low-Noise Amplifier

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

0.9–10GHz low noise amplifier with capacitive cross coupling

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A 6.512-GHz Balanced Variable-Gain Low-Noise Amplifier With Frequency-Selective Gain Equalization Technique

A 6.5-12 GHz Balanced Variable Gain Low-Noise Amplifier with Frequency-Selective Non-Foster Gain Equalization Technique

A Highly Linear 2.4GHz Low Noise Amplifier

A High-Linearity Wideband Common-Gate LNA with a Differential Active Inductor.

Ultralow Power E-Band Low-Noise Amplifier with Three-Stacked Current-Sharing Amplification Stages in 28-Nm CMOS

Compact 50-62 GHz Current-Reused Low-Noise Amplifier with Gate-Drain Transformer Feedback

A 0.061-mm2 1–11-GHz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward With Simultaneous Current and Noise Reduction

An Inductorless Wideband Common-Gate Lna with Dual Capacitor Cross-Coupled Feedback and Negative Impedance Techniques

A Power Reduction Technique for Wideband Common Gate Low Noise Amplifers

A Capacitor Assisting Triple-Winding Transformer Low-Noise Amplifier with 0.8-1.5Db NF $6-12\Text{ghz BW} \pm 0.75\text{db}$ Ripple in 130nm SOI CMOS

A 140 GHz, 4 Db Noise-Figure Low-Noise Amplifier Design with the Compensation of Parasitic Capacitance CGS

A Capacitor Assisting Triple-Winding Transformer Low-Noise Amplifier with 0.8-1.5dB NF 6-12GHz BW 0.75dB Ripple in 130nm SOI CMOS

A 0.03-3Ghz Inductorless Wideband Low Noise Amplifier in 65nm CMOS

A 52–73-GHz LNA With Tri-Coupled Transformer for G m Boosting and Enhanced Noise Canceling

A V-Band Compact LNA With G<inf>m</inf>-Boosting and Noise-Cancelling Technique

A Low Power Inductorless Wideband LNA With G m Enhancement and Noise Cancellation

A 3.4 Db Nf K-Band Lna with A Tapped Capacitor Matching Network in 65 Nm Cmos Technology