Abstract:This article presents a numerical short-open-load (SOL) calibration technique for accurate extraction of electrically small planar/nonplanar microstrip-line (MSL) circuits and elements in the interface of 3-D full-wave algorithm or simulator. An additional matched-load condition is established at the reference plane and employed in the whole calibration process. In comparison with the traditional short-open calibration (SOC) method, the proposed SOL technique implemented in the interface of software does not inquire prior simulation of the internal current/voltage at the reference plane of two calibration standards but only needs to know the external port impedances of three calibration standards. After the description of entire extraction process, a few typical electrically small planar circuits, such as MSL open-end and step discontinuities, are first numerically deembedded, and their extracted circuit parameters are evidently confirmed with other published ones. Then, a nonplanar structure of a vertically placed shorting pin in the middle of MSL is studied with different sizes and positions to effectively extract the circuit parameters in the two presented equivalent models. Finally, a third-order Chebyshev filter is designed with pin-loaded MSL structures. Its frequency response is synthesized on the proposed SOL method to validate the correctness of the extracted circuit parameters and further demonstrate the usefulness of this method in synthesis design of electrically large microwave circuits. Good agreement among the filtering frequency responses from equivalent circuit model, full-wave simulation, and measurement has well revealed that the proposed SOL method is indeed accurate in numerical extraction of circuit elements and efficient in synthesis design of an entire circuit with prescribed specifications.

NEW CALIBRATION METHOD FOR RADIAL LINE EXPERIMENT

MMIC on-Wafer Test Method Based on Hybrid Balanced and Unbalanced RF Pad Structures

Calibrate the Non-Orthogonal Error of AFM with Two-Dimensional Self-Traceable Grating.

A Novel Four-Port Symmetric Probe Calibration Method for On-Wafer S-Parameter Measurement

A Method to Calibrate Beam Position Monitor at HLS 200 MeV Linac

An Improved Line-Reflect-Reflect-Match Calibration With an Enhanced Load Model

A New SOLT Calibration Method for Leaky On-Wafer Measurements Using a 10-Term Error Model

A Novel Four-Port Calibration Method for High Frequency On-Wafer S-parameter Measurement

Calibration rod selection strategy in RCSA-based method for reliable calculation of milling tool-tip FRFs in rotating conditions

Practical and Accurate Method for Aspheric Misalignment Aberrations Calibration in Non-Null Interferometric Testing

Design And Optimization Of The Diamagnetic Lateral Force Calibration Method

Efficient Calibration of a Scanning Probe on CMM

Numerical Short-Open-Load (SOL) Calibration Technique for Accurate Extraction of Electrically-Small Planar/Non-Planar Microstrip-Line Circuits

A novel robot calibration method with plane constraint based on dial indicator

The Design and Fabrication of a MEMS Electronic Calibration Chip

Symmetric-Reciprocal-Match Method for Vector Network Analyzer Calibration

In Situ Calibration of Magnetic Field Coils Using Parametric Resonance in Optically-pumped Magnetometers

A New Uniform Calibration Method for Double-Sided Silicon Strip Detectors

An Improved Design of the MultiCal On-Site Calibration Device for Industrial Robots

Four-Port SOLR Calibration Algorithm for Symmetric GSSG Probes