Abstract:The detection of depth-of-interaction (DOI) is a critical detector capability to improve the PET spatial resolution uniformity across the field-of-view and will significantly enhance, in particular, small bore system performance for brain, breast, and small animal imaging. One promising technique of DOI detection is to use dual-ended-scintillator readout that uses two photon sensors to detect scintillation light from both ends of a scintillator array and estimate DOI based on the ratio of signals (similar to Anger logic). This approach needs a careful DOI function calibration to establish accurate relationship between DOI and signal ratios, and to recalibrate if the detection condition is shifted due to the drift of sensor gain, bias variations, or degraded optical coupling, etc. However, the current calibration method that uses coincident events to locate interaction positions inside a single scintillator crystal has severe drawbacks, such as complicated setup, long and repetitive measurements, and being prone to errors from various possible misalignments among the source and detector components. This method is also not practically suitable to calibrate multiple DOI functions of a crystal array. To solve these problems, a new method has been developed that requires only a uniform flood source to irradiate a crystal array without the need to locate the interaction positions, and calculates DOI functions based solely on the uniform probability distribution of interactions over DOI positions without knowledge or assumption of detector responses. Simulation and experiment have been studied to validate the new method, and the results show that the new method, with a simple setup and one single measurement, can provide consistent and accurate DOI functions for the entire array of multiple scintillator crystals. This will enable an accurate, simple, and practical DOI function calibration for the PET detectors based on the design of dual-ended-scintillator readout. In addition, the new method can be generally applied to calibrating other types of detectors that use the similar dual-ended readout to acquire the radiation interaction position.

A New Uniform Calibration Method for Double-Sided Silicon Strip Detectors

The Application of Piecewise Direct Standardization with Snv in Calibration Transfer of Raman Spectra

Calibrate the Non-Orthogonal Error of AFM with Two-Dimensional Self-Traceable Grating.

A Phase Calibration Method for Single Channel Monopulse Tracking Systems Based on Curve Fitting Technique

Study on Calibration Method for the Performance Index of SPR Sensors

A Calibration and Correction Method for the Measurement System Based on Four-Quadrant Detector

A Novel Method to Calibrate Doi Function of A Pet Detector with A Dual-Ended-Scintillator Readout

Flexible Calibration Method for an Inner Surface Detector Based on Circle Structured Light

Test of Double-sided Multi-strip Silicon Detectors

Random Noise Reduction with More Accurate Calibration for a Spectrometer Using a Two-Dimensional Array Detector

Charge Collection and Equalization for Position-Sensitive Silicon Strip Detector

Fast Calibration Methods Using Cosmic Rays for a Neutron Detection Array

Optimization Study of Spacing Between Strips for Silicon Strip Detector by Simulation

Investigation of the Thickness Non-Uniformity of the Very Thin Silicon-Strip Detectors

Virtual Point Source Synthesis method for 3D Scintillation Detector Characterization

Monolithic Pet Detector Calibration Using Uncollimated Source and Gamma Interaction Position Distribution Constraint

A wavelength calibration process for micro-spectrometers with multichannel detectors

Development of a Light Yield Calibration Method for Μsr Detectors Based on Compton Edge Location

A wavelength calibration process for micro-spectrometers with multichannel detectors - art. no. 68291Q

Calibration of Dual-Channel Raman Spectrometer via Optical Frequency Comb

A Method to Calibrate Beam Position Monitor at HLS 200 MeV Linac