Abstract:Solid concentration and particle velocity distributions in the transition section of a ϕ 200mm turbulent fluidized bed (TFB) and a ϕ 200mm annulus turbulent fluidized bed (A-TFB) with a ϕ 50mm central standpipe were measured using a PV6D optical probe. It is concluded that in turbulent regime, the axial distribution of solid concentration in A-TFB was similar to that in TFB, but the former had a shorter transition section. The axial solid concentration distribution, probability density, and power spectral distributions revealed that the standpipe hindered the turbulence of gas–solid two-phase flow at a low superficial gas velocity. Consequently, the bottom flow of A-TFB approached the bubbling fluidization pattern. By contrast, the standpipe facilitated the turbulence at a high superficial gas velocity, thus making the bottom flow of A-TFB approach the fast fluidization pattern. Both the particle velocity and solid concentration distribution presented a unimodal distribution in A-TFB and TFB. However, the standpipe at a high gas velocity and in the transition or dilute phase section significantly affected the radial distribution of flow parameters, presenting a bimodal distribution with particle concentration higher near the internal and external walls and in downward flow. Conversely, particle concentration in the middle annulus area was lower, and particles flowed upward. This result indicated that the standpipe destroyed the core-annular structure of TFB in the transition and dilute phase sections at a high gas velocity and also improved the particle distribution of TFB. In conclusion, the standpipe improved the fluidization quality and flow homogeneity at high gas velocity and in the transition or dilute phase section, but caused opposite phenomena at low gas velocity and in the dense-phase section.

Study of Fluidization Behavior Transition from Geldart B to A Induced by High Temperature Using Electrical Capacitance Tomography

Particle Velocity Measurements in Transition Section of Turbulent Fluidized Beds Using Optical Fiber Probe and CFD Simulation

Solid Concentration and Velocity Distributions in an Annulus Turbulent Fluidized Bed

Fluidization of Cohesive Fluorite Particles at Ambient/High Temperatures and Enhancement Methods

High-temperature electrical capacitance tomography for gas–solid fluidised beds

Characterization of Particle Fluidization Pattern in a Gas Solid Fluidized Bed Based on Acoustic Emission (AE) Measurement

Particle Fluidization Characteristics and Transition in a Hot Gas-Solid Fluidized Bed with Liquid Injection

Measuring minimum fluidization velocity of Geldart particles by use of electrical capacitance tomography

Measurement of the Fluidized Velocity in Gas-Solid Fluidized Beds Based on AE Signal Analysis by Wavelet Packet Transform

Experimental Investigation of Electrostatic Effect on Particle Motions in Gas-Solid Fluidized Beds

Monitoring of Particle Motions in Gas-Solid Fluidized Beds by Electrostatic Sensors

On the Concentration Models in Electrical Capacitance Tomography for Gas-Fluidized Bed Measurements

Fluidization behavior in high-pressure water at temperature from ambient to supercritical

On Coherent Structures in Gas–solid Fluidization

Flow Characteristics and Defluidization Behavior with Agglomeration at High Temperature Fluidized Bed

Investigation of flow characteristics in a rectangular spouted fluidized bed using electrical capacitance volume tomography

Application of electrical capacitance tomography for gas-solid fluidized bed measurement

Effects of Interparticle Forces on Fluidization Characteristics in Liquid-Containing and High-Temperature Fluidized Beds

Experimental Verification of Solid-Like and Fluid-Like States in the Homogeneous Fluidization Regime of Geldart A Particles

Effect of Electrode Length of an Electrical Capacitance Tomography Sensor on Gas−Solid Fluidized Bed Measurements

Experimental study on gas–solids flows in a circulating fluidised bed using electrical capacitance tomography