Abstract:Electrical capacitance tomography (ECT) has been widely applied in gas-fluidized bed measurements, which however is constrained by the sensor designs, image reconstruction algorithms and concentration models owing to the "soft-field " nature. Among the three factors, the concentration models that map the permittivity to solid concentration distribution are less understood. In this paper we present an experimental investigation on the effects of concentration models for the ECT measurements of gas-fluidized beds containing Geldart's group A particles. The results show that the bubble velocity, bubbling frequency and fluidization regime transition velocity are intrinsic whatever the concentration model employed. However, the time-averaged solid concentrations measured by ECT with the conventional concentration models are usually higher than the corresponding results obtained by the bed expansion experiments in homogeneous fluidization. It has been further found that the concentration models can significantly influence the threshold selection in identifying the bubbles and surrounding emulsion phase in gas-fluidized beds. Thus, a new concentration model given in the formula of a power function (phi = G(alpha)) has been proposed, with the optimal exponent alpha obtained via the least-square fitting of solid concentration in bed expansion during homogeneous fluidization. The model is robust and the sensitivity analysis shows that the variation of time-averaged solid concentration is negligible (& LE; 3%) suppose that alpha changes by & PLUSMN; 20%.

Application of electrical capacitance tomography for gas-solid fluidized bed measurement

Application Of Electrical Capacitance Tompgraphy To Gas-Solid Fluidized Beds: Dynamic Behavior Monitoring

Study on Voidage Measurement of Gas-solid Fluidized Bed by Using Electrical Capacitance Tomography

Experimental study on gas–solids flows in a circulating fluidised bed using electrical capacitance tomography

High-temperature electrical capacitance tomography for gas–solid fluidised beds

Soft-sensing System of Gas-Solid Fluidized Bed

Effect of Electrode Length of an Electrical Capacitance Tomography Sensor on Gas−Solid Fluidized Bed Measurements

A Machine Learning Approach for Electrical Capacitance Tomography Measurement of Gas–solid Fluidized Beds

Measurement Of Gas-Solid Flow Pattern In Rectangle Cross-Section In Cfb By Electrical Capacitance Tomography

Measuring minimum fluidization velocity of Geldart particles by use of electrical capacitance tomography

Monitoring of Particle Motions in Gas-Solid Fluidized Beds by Electrostatic Sensors

Investigation of flow characteristics in a rectangular spouted fluidized bed using electrical capacitance volume tomography

On the Concentration Models in Electrical Capacitance Tomography for Gas-Fluidized Bed Measurements

Combing mobile electrical capacitance tomography with Fourier neural operator for 3D fluidized beds measurement

A Comparative Study of Electrostatic Current and Pressure Signals in a MSFC Gas–solid Fluidized Bed

Measurement of Flow Pattern in Fluidized Bed Based on Acoustic Emission and Complexity Analysis

Detection of Sheeting in Polyethylene Gas-Solid Fluidized Bed by Measuring Electrostatic Current

A new method for the velocity measurement of gas-liquid two-phase flow

Measurement of Bed Level in Gas-Solid Fluidized Bed by Ultrasonic Technique

Measurement of Flow Pattern and Bed Level of Gas-solid Fluidized Bed in Borstar Process by Acoustic Emission Technique

Dynamic Voidage Measurements in A Gas Solid Fluidized Bed by Electrical Capacitance Tomography