Abstract:The MEMS sensor converts the physical signal of nature into an electrical signal. The output signal of the MEMS sensor is so weak and basically in the low-frequency band that the MEMS sensor interface circuit has a rigorous requirement for the noise/offset and temperature coefficient, especially in the bandgap reference block. However, the traditional amplifier has low-frequency noise and offset voltage, which will decrease the precision of the bandgap reference. In order to satisfy the need of the MEMS sensor interface circuit, a high-precision and low-noise bandgap reference is proposed in this paper. A novel operational amplifier with a chopper-stabilization technique is adopted to reduce offset and low-frequency noise. At the same time, the V-curve compensation circuit is used to realize the second-order curvature compensation. The circuit is implemented under the 0.18 μm standard of the CMOS process. The test result shows that the temperature coefficient of the bandgap is 2.31 ppm/°C in the range of -40-140 °C, while the output voltage noise is only 616 nV/sqrt(Hz)@1 Hz and the power-supply rejection ratio is 73 dB@10 kHz. The linear adjustment rate is 0.33 mV/V for supply voltages of 1.2-1.8 V at room temperature, the power consumption is only 107 μW at 1.8 V power supply voltage, and the chip active area is 0.21 × 0.28 mm2.

Low-power Offset-Cancellation Switched-Capacitor Correlated Double Sampling Bandgap Reference

A Low Drift Curvature-Compensated Bandgap Reference with Trimming Resistive Circuit

A Novel Switched Capacitor Bandgap Reference with a Correlated Double Sampling Structure

A bandgap reference circuit with the nominal reference voltage adjusted accurately

A New Digital to Analog Converter Based on Low-Offset Bandgap Reference.

A 6 Ppm/°c Capacitively-Biased Diode Based Novel Bandgap Circuit with Driving Capability and Calibration

A 14-B BW /power Scalable Sensor Interface with a Dynamic Bandgap Reference

An Ultra-Low Power 14.6ppm/°c 1.2V Bandgap Voltage Reference with Low Leakage Sample-and-Hold Switch

A 1.2 V,9 Ppm/℃ CMOS Bandgap Voltage Reference

A Power-Efficient Reference Buffer with Wide Swing for Switched-Capacitor ADC

Design of an Offset Voltage Compensation Ratio-Capacitance Bandgap Voltage Reference

A Design With High Order Compensation and low Temperature Drift Bandgap Reference Voltage Source

A High-Precision Bandgap Reference with Chopper Stabilization and V-Curve Compensation Technique

Charge-Compensation-Based Reference Technique For Switched-Capacitor Adcs

A Low Noise Bandgap Reference Voltage Source for CMOS Temperature Sensors

A Low-Offset Dynamic Comparator with Input Offset-Cancellation

An Offset-Compensated Switched-Capacitor Interface Circuit for Closed-Loop Mems Capacitive Accelerometer

A Curvature Corrected Bandgap Reference with Mismatch Cancelling and Noise Reduction

A Ultra Low Power Dissipation CMOS Bandgap Reference

A High-Performance Sample-and-Hold Circuit with Sampling Bandwidth Compensation

A CMOS bandgap reference based on switched capacitor with temperature compensation method