Abstract:The MEMS sensor converts the physical signal of nature into an electrical signal. The output signal of the MEMS sensor is so weak and basically in the low-frequency band that the MEMS sensor interface circuit has a rigorous requirement for the noise/offset and temperature coefficient, especially in the bandgap reference block. However, the traditional amplifier has low-frequency noise and offset voltage, which will decrease the precision of the bandgap reference. In order to satisfy the need of the MEMS sensor interface circuit, a high-precision and low-noise bandgap reference is proposed in this paper. A novel operational amplifier with a chopper-stabilization technique is adopted to reduce offset and low-frequency noise. At the same time, the V-curve compensation circuit is used to realize the second-order curvature compensation. The circuit is implemented under the 0.18 μm standard of the CMOS process. The test result shows that the temperature coefficient of the bandgap is 2.31 ppm/°C in the range of -40-140 °C, while the output voltage noise is only 616 nV/sqrt(Hz)@1 Hz and the power-supply rejection ratio is 73 dB@10 kHz. The linear adjustment rate is 0.33 mV/V for supply voltages of 1.2-1.8 V at room temperature, the power consumption is only 107 μW at 1.8 V power supply voltage, and the chip active area is 0.21 × 0.28 mm2.

A Low Noise Bandgap Reference Voltage Source for CMOS Temperature Sensors

A Low Drift Curvature-Compensated Bandgap Reference with Trimming Resistive Circuit

Design and Realization of a High Precision Low Temperature Coefficient Bandgap Voltage Reference

A bandgap reference circuit with nominal value adjustable

A 0.8V Capacitively-Biased BJT-Based Temperature Sensor with an Inaccuracy of ±0.4°C ($\mathbf{3}\mathbf{\sigma}$) from −40°C to 125°C in 22nm CMOS

A 1.2 V,9 Ppm/℃ CMOS Bandgap Voltage Reference

A 1.2V Self-Referenced Temperature Sensor with a Time-Domain Readout and a Two-Step Improvement on Output Dynamic Range

A 0.8V CMOS bandgap voltage reference design

A Low Voltage High Precision CMOS Bandgap Reference

A High-Precision Bandgap Reference with Chopper Stabilization and V-Curve Compensation Technique

A low noise and low temperature coefficient CMOS bandgap reference for MEMS micro-accelerometer

A high-precision compensated CMOS bandgap voltage reference without resistors

A 1V Supply, 81nW, 800mv Bandgap Reference Voltage Circuit for Low Power Devices

A 0.18μm CMOS band-gap voltage reference

A Novel CMOS Current Mode Bandgap Reference

Cmos 2.5v Bandgap Voltage Reference

A CMOS Bandgap Reference with 1V Supply

Low Supply Bandgap Voltage Reference

A CMOS Band-Gap Voltage Reference with Low Offset

A Ultra Low Power Dissipation CMOS Bandgap Reference

Improved Design of a Super Low Voltage Reference