Abstract:This paper presents characterization and compensation of the thermal bias drift of a MEMS accelerometer whose effective stiffness is electrostatically tuned to a low value with the help of the single-sided parallel plates (SSPPs) capacitors. A temperature drift model for the proposed accelerometer is built and the temperature effect on the mechanical stiffness and the circuit gains is characterized. The characterization reveals that the variations of the feedforward coefficient including the mechanical stiffness and the readout gain due to the temperature change play a significant role in the bias drift of output of the proposed closed-loop accelerometer. On the other hand, the variations of both feedback gain and tuning gain as a function of temperature are one-order-of-magnitude less than that of the feedforward coefficient. To calibrate the feedforward coefficient, an excitation signal as a form of AC reference displacement is introduced to drive the proof mass and the readout response is demodulated to calibrate the variance of the feedforward coefficient correspondingly. An open-loop compensation scheme for the temperature-induced bias drift using the variance of the calibrated response is proposed accordingly. Alternatively, the calibrated response can be controlled to a preset value by a new proportion integral derivative (PID) controller by the adjustment of the SSPP tuning voltage. The output of the PID controller is used for the calibration of the introduced bias from the electrostatic tuning force. Therefore, a closed-loop compensation of the thermal bias drift is achieved by remaining the feedforward coefficient while eliminating the calibrated bias. Experiments under a temperature cooling process and different tuning voltages are carried out to verify two proposed compensation schemes. The temperature drift coefficients (TDCs) of both compensated outputs exhibit at least one-order-of-magnitude reduction in response to the temperature change. When the effective stiffness of the accelerometer is tuned to about 4.19 N m(-1), the TDC of the compensated output using the proposed open-loop or closed-loop compensation schemes is reduced to about 0.1136 or 0.0391 mg degrees C-1, respectively and meanwhile, the Allan bias instability is slightly increased to 48.63 or 56.14 mu g, respectively.

An Offset-Compensated Switched-Capacitor Interface Circuit for Closed-Loop Mems Capacitive Accelerometer

Cmos Interface Circuitry For A Closed-Loop Capacitive Mems Accelerometer

A Stiffness-Tunable MEMS Accelerometer

Design Of The Closed-Loop Capacitive Micro-Accelerometer Based On Pspice

A Low-Noise Closed-Loop Interface For High-G Capacitive Micro-Accelerometer

A Low-Noise Low-Offset CMOS Readout Circuit for MEMS Capacitive Accelerometers

A Closed-Loop Mems Accelerometer with Capacitive Sensing Interface Asic

CMOS interface circuit for closed-loop accelerometer

Design of Force-Balance Capacitive Accelerometer

Noise Behaviors of a Closed-Loop Micro-Electromechanical System Capacitive Accelerometer

A High-Voltage Closed-Loop SC Interface for a ± 50 G Capacitive Micro-Accelerometer with 112.4 Db Dynamic Range

A low-noise CMOS interface circuit for closed-loop accelerometer

A low-noise switched-capacitor interface for a capacitive micro-accelerometer

Characterization and Compensation of Thermal Bias Drift of a Stiffness-Tunable MEMS Accelerometer

A Capacitive Interface Circuit with Capacitor Mismatch Auto-compensation for MEMS Gyroscope.

Low Noise Interface ASIC of Capacitive MEMS Accelerometer

A control and readout circuit with capacitive mismatch auto-compensation for MEMS vibratory gyroscope

Interface circuit with zero compensation function for capacitive microaccelerometers

Full Differential CMOS Interface Circuit for Closed-Loop Capacitive Micro-Accelerometers

Design Of Readout Circuits Used For Micro-Machined Capacitive Accelerometer

A Low-Noise High-G Closed-Loop Capacitive Accelerometer Using Dc-Blocking Technique For Reduction Of Power Dissipation