Abstract:In this paper, a new non-uniform differential sample and hold circuit is proposed using low-distortion sampling switches for biomedical signal processing applications. The proposed design can be used in the biomedical low-frequency range with low-power consumption which makes the proposed design a good candidate for bio-signal sampling purposes. The body biasing technique is employed to reduce the distortion of the sampling switches. Moreover, to reduce the required sampled-data storage capacity, the signal slope rate detection is used to predict the input signal frequency and variations in order to adjust the proper sampling rate of the proposed non-uniform sampling circuit. To realize the proposed design, a capacitive digital-to-analog converter is used to sample the slope changes of signals at two sampling frequencies of 1000 and 100 Hz. The circuit simulation results using 0.18 μm CMOS technology parameters at 1 V supply voltage, indicate the saving in power consumption value up to 57.5% in comparison with other conventional designs. Additionally, the output signal of the proposed circuit can be reconstructed with a percentage root-mean-square difference factor of as low as 2.1%, a mean square error of 0.0025, and a signal-to-noise ratio value of 79.34 dB.

A High-Performance Sample-and-Hold Circuit with Sampling Bandwidth Compensation

Optimization Of Sample/Hold Circuit For High-Speed And High-Resolution Adcs

A Low Power Sample-and-Hold Circuit for Pipelined A/D Converter

Design of a High-Speed Sample-and-hold Circuit Using a Substrate-Biasing-effect Attenuated T Switch

High gain, high speed OTA for S/H circuit in 14-b 100-MS/s Pipeline ADC

A sample and hold circuit for high speed ADCs

Low power design for 14-bit 100MSPS pipelined ADC

Design of a Sample-and-Hold Circuit for High Speed CMOS Image Sensor

A High-Speed High-Resolution Sample-and-Hold Circuit

A Sample/Hold Circuit for Low-Power High-Resolution A/D Converters

An Undersampling High-Resolution Low-Power Sample-and-Hold Circuit

A High Performance CMOS Sample and Hold Circuit

A CMOS high performance 50MS/s sample/hold circuit

A 12-Bit 200-Ms/s Sample-and-hold Amplifier with a Hybrid Miller-Feedforward Compensation Technique

An S/H circuit with parasitics optimized for IF-sampling

A High-Performance,Low-Power ΣΔ Modulator for Digital Audio Applications

A 1.2V Sample-and-Hold Circuit for 14-Bit 250MS/s Pipeline ADC in 65nm CMOS

A 10-bit 20-Msample/s 49mW CMOS pipelined A/D converter

High Linearity Front- End Circuit for RF Sampling ADCs with Nonlinear Junction Capacitor Cancellation

Improving Source-Follower Buffer For High-Speed Adc Testing

A New Low-Power Non-uniform Sample and Hold Circuit for Biomedical Signal Processing Applications