Abstract:Pulsed power technology has traditionally served in the field of defense technology and is generally operated in a single operation. With the increasing demand in the military and high-energy physics fields, especially in the fields of medicine [1], industry, environmental protection and electromagnetic interference, the demand for high average power is becoming more and more urgent, requiring the pulse source to be in a high repetition frequency operating state. The high-repetition-frequency high-voltage pulse source is a pulse power system that can operate at high repetition frequencies and generate high voltage pulses. Ultra-wideband electrical pulse sources with small size and all solid-state structures are easier to integrate into the system and compatible with other devices. This paper introduces the design and implementation of a high-repetition-frequency high-voltage pulse generating device. The device is mainly composed of a pulse signal source module, a power amplification module and a pulse compression module. The article describes in detail about the pulse signal generation module based on MCU (micro-controller unit) and FPGA (field programmable gatearray) with adjustable frequency adjustable pulse width at the source level, the pulse signal power amplification module based on DSRD (drift step recovery diode) [2] switch, the pulse compression module based on the principle of diode reverse recovery. The final test results show that the device can work at 1MHz repeat frequency, the output pulse peak voltage can be up to 1700V on 50 Omega load, the output pulse rising edge is less than 1 ns, and the half pulse width is up to 1.9 ns. If the pulse compression module is connected, the half pulse width can reach 1.56 ns and the compression ratio can reach 87%.

All-Solid-State Ultrashort Pulse Generator by Capacitive Chopping Circuit

Development of P-C Switch with Adjustable Gap

High-Voltage Ultrashort Pulse Power Module with MHz Repetition Rate Based on SSST

A Repetitive High Voltage Pulse Adder Based on Solid State Switches

An Amplitude-Programmable Energy-Recycling High-Voltage Resonant Pulser for Battery-Powered Ultrasound Devices

High Voltage Nanosecond Pulse Generator Based on Inductive Energy Storage with Adjustable Pulse Width

Nanosecond Pulse Generator Based on an Unbalanced Blumlein-Type Multilayered Microstrip Transmission Line and Solid-State Switches

Design of a High Voltage Pulse Generator with Large Width Adjusting Range for Tumor Treatment

High-voltage Subnanosecond Pulsed Power Source with Repetitive Frequency Based on Marx Structure

Repetitive High Voltage Rectangular Waveform Pulse Adder for Pulsed Discharge of Capacitive Load

Nanosecond High Voltage Pulse Generator for Biological and Biomedical Application

Design, Implementation And Analysis Of Solid-State Megahertz Continuous High-Repetition-Frequency High-Voltage Pulse Source

Full-Bridge Modular Multilevel Submodule-Based High-Voltage Bipolar Pulse Generator With Low-Voltage DC, Input for Pulsed Electric Field Applications

One type of high voltage bipolar square pulser based on all-solid-state switch devices

Compact repetitive high voltage nanosecond pulse generator

The high voltage nanosecond electric pulse generator based on a photoconductive semiconductor switch

A Multiparameter Adjustable, Portable High-Voltage Nanosecond Pulse Generator Based on Stacked Blumlein Multilayered PCB Strip Transmission Line

10 Kv Nanosecond Pulse Generator with High Voltage Gain and Reduced Switches

Design of Compact High-Voltage Capacitor Charging Power Supply for Pulsed Power Application

High-Voltage Pulsed Power Based On Series-Connected Full-Bridge And Solid-State Switches

Solid-State Spiker-Sustainer Circuit Consisting of PFN and SOS