Abstract:A high ratio (winding ratio of 1:80) pulse transformer with a modular ferrite core was developed for a repetitive resonant charging system. The magnetic core is constructed from 68 small blocks of ferrites, glued together by epoxy resin. This allows a high degree of freedom in choosing core shape and size. Critical issues related to this modular design are the size tolerance of the individual ferrite blocks, the unavoidable air gap between the blocks, and the saturation of the core. To evaluate the swing of the flux density inside the core during the charging process, an equivalent circuit model was introduced. It was found that when a transformer is used in a resonant charging circuit, the minimal required volume of the magnetic material to keep the core unsaturated depends on the coupling coefficient of the transformer and is independent of the number of turns of the primary winding. Along the flux path, 17 small air gaps are present due to the inevitable joints between the ferrite blocks. The total air gap distance is about 0.67 mm. The primary and secondary windings have 16 turns and 1280 turns, respectively, and the actually obtained ratio is about 1:75.4. A coupling coefficient of 99.6% was obtained. Experimental results are in good agreement with the model, and the modular ferrite core works well. Using this transformer, the high-voltage capacitors can be charged up to more than 70 kV from a low-voltage capacitor with an initial charging voltage of about 965 V. With 26.9 J energy transfer, the increased flux density inside the core was about 0.23 T, and the core remains unsaturated. The energy transfer efficiency from the primary to the secondary was around 92%.

A Repetitive High Voltage Pulse Adder Based on Solid State Switches

A Repetitive Pulser with Four Spark Gap Switches

Repetitive High Voltage Rectangular Waveform Pulse Adder for Pulsed Discharge of Capacitive Load

An Efficient, Repetitive Nanosecond Pulsed Power Generator with Ten Synchronized Spark Gap Switches

Investigation on a Novel Multiple-Switch Pulsed Power Technology

Novel Multiple-switch Pulsed Power Technologies

Long Lifetime, Triggered, Spark-Gap Switch For Repetitive Pulsed Power Applications

Repetitive High-Voltage Pulse Modulator Using Bipolar Marx Generator Combined with Pulse Transformer

A pulsed power generator with a 20 stage transmission-line-transformer and 20 spark-gap switches

All Solid-State Marx Modulator with Bipolar High-Voltage Fast Narrow Pulses Output

A High-Voltage Pulse Transformer with a Modular Ferrite Core.

Experimental research on MHz repetition rate solid-state modulator

High-voltage pulse waveform modulator based on solid-state Marx generator

A Triggered Spark-Gap Switch for High-Repetition Rate High-Voltage Pulse Generation

All-solid-state Pulse Adder with Bipolar High Voltage Fast Narrow Pulses Output

Repetitive and High Voltage Marx Generator Using Solid-State Devices

The Development of Solid-state Pulse Generator Based on Marx Circuit with Chopping Switch

All Solid-State Pulsed Power Generator with Semiconductor and Magnetic Compression Switches

All-Solid-State Repetitive Pulsed-Power Generator Using IGBT and Magnetic Compression Switches

A Flexible Solid-State Marx Modulator Module Based on Discrete Magnetic Coupling Drivers

An All Solid-State High-Voltage Rectangular Pulse Generator