Abstract:Pulsed power technology has traditionally served in the field of defense technology and is generally operated in a single operation. With the increasing demand in the military and high-energy physics fields, especially in the fields of medicine [1], industry, environmental protection and electromagnetic interference, the demand for high average power is becoming more and more urgent, requiring the pulse source to be in a high repetition frequency operating state. The high-repetition-frequency high-voltage pulse source is a pulse power system that can operate at high repetition frequencies and generate high voltage pulses. Ultra-wideband electrical pulse sources with small size and all solid-state structures are easier to integrate into the system and compatible with other devices. This paper introduces the design and implementation of a high-repetition-frequency high-voltage pulse generating device. The device is mainly composed of a pulse signal source module, a power amplification module and a pulse compression module. The article describes in detail about the pulse signal generation module based on MCU (micro-controller unit) and FPGA (field programmable gatearray) with adjustable frequency adjustable pulse width at the source level, the pulse signal power amplification module based on DSRD (drift step recovery diode) [2] switch, the pulse compression module based on the principle of diode reverse recovery. The final test results show that the device can work at 1MHz repeat frequency, the output pulse peak voltage can be up to 1700V on 50 Omega load, the output pulse rising edge is less than 1 ns, and the half pulse width is up to 1.9 ns. If the pulse compression module is connected, the half pulse width can reach 1.56 ns and the compression ratio can reach 87%.

Repetitive High Voltage Rectangular Waveform Pulse Adder for Pulsed Discharge of Capacitive Load

Development of Electropulsing Treatment Device Based on Capacitor Energy Storage and Discharge

A Repetitive High Voltage Pulse Adder Based on Solid State Switches

A Repetitive Pulser with Four Spark Gap Switches

All-solid-state Pulse Adder with Bipolar High Voltage Fast Narrow Pulses Output

Research of Magnetic Self-Balance Used in a Repetitive High Voltage Rectangular Waveform Pulse Adder

All-Solid-State Ultrashort Pulse Generator by Capacitive Chopping Circuit

An All Solid-State High-Voltage Rectangular Pulse Generator

A Compact Repetitive Unipolar Nanosecond-Pulse Generator for Dielectric Barrier Discharge Application

Development of a 100 Ka-Level Heterogeneous Homogeneous Repetitive Frequency Pulse Power Supply

Repetitive Frequency Marx Generator Based on Magnetic Switches and Its Application in Dielectric Barrier Discharge

Design, Implementation And Analysis Of Solid-State Megahertz Continuous High-Repetition-Frequency High-Voltage Pulse Source

Development of P-C Switch with Adjustable Gap

A solid-state bipolar pulse adder based on phase-shifted control

An Efficient All Solid-State Pulsed Generator for Pulsed Discharges

Repetitive High Voltage All-Solid-State Marx Generator For Dielectric Barrier Discharge Pulsed Plasma

A Novel All Solid-State Sub-Microsecond Pulse Generator for Dielectric Barrier Discharges

Repetitive High-Voltage Pulse Modulator Using Bipolar Marx Generator Combined with Pulse Transformer

A high repetition-rate bipolar submicrosecond pulse generator based on magnetic pulse compression system

A Novel Repetitive High-Voltage Resonant Pulse Generator for Plasma-Assisted Milling

A Distributed High-Voltage Arbitrary Waveform Generator Based on Versatile Pulsed Power Module