Abstract:Microhole measurement methods struggle to produce the intended results because of poor in situ measurement circumstances. The back-pressure air gauge, which is self-clean and unaffected by complicated environments, can be equipped with a microprobe to obtain desired results, but the limited application of the sensor is caused by its expensive cost and challenging processing requirements. In this article, an air gauging sensor without a microprobe was presented as a low-cost and simple structure solution to the above issue and the static characteristics were optimized in several methods accounting for different microhole diameters. Theoretical and experimental static characteristics were obtained using the steady-state model and experimental data. Then, the effects of crucial parameters on static characteristics, including the feeding pressure and the inlet nozzle diameter, were analyzed under various settings. A novel performance improvement method of the sensor was presented by comparing and analyzing the ${P}_{{\text {x}}}$ = ${f}$ ( ${d}_{{{1}}}$ ) and ${P}_{{\text {x}}}$ = ${f}$ ( ${d}_{{{1}}} ^{{2}}$ ) characteristics. The results indicated that a smaller inlet nozzle and appropriately higher feeding pressure helped improve the sensitivity, reduce the starting diameter, and enlarge the length of the linear area. The novel method of extending the measurement range by combining ${P}_{{\text {x}}}$ = ${f}$ ( ${d}_{{{1}}}$ ) with ${P}_{{\text {x}}}$ = ${f}$ ( ${d}_{{{1}}} ^{{2}}$ ) has a larger measurement range and a smaller starting diameter than sacrificing 1% nonlinear error. It is possible to use the nonlinear area to measure microholes much smaller than the starting diameter. These new findings make contributions to the wide application of the air gauging sensor in microhole measurements.

The Mechanism of Errors Generated from Slug Inside Pinhole in Pressure Measurement

PRESSURE FLUCTUATIONS OF LIQUID-LIQUID SLUG FLOW IN CROSS-JUNCTION SQUARE MICROCHANNELS

Machining Precision Online Measurement of Large Span Pin Hole Using Structured Light

Discontinuous pinning effect by a hole row to the gas-liquid interface in a parallel gap

Research on Pressure Measurement Model Using Surface Wave Considering Temperature Effect

Error Analysis of a Spherical Capacitive Sensor for the Micro-Clearance Detection in Spherical Joints

Geometric Analysis of Measurement Errors in a Surface Metrology Class with Closed-Loop Probes

A Study on the Pressure Leakage Correction of Pistonphones at Infrasonic Frequencies

Design and Accuracy Analysis of Pneumatic Gauging for Form Error of Spool Valve Inner Hole

Research on Pneumatic Measurement System for Inner Hole Cylindricity Error of Slide Valve

Analysis of mechanism producing error at flowmeter of pressuredifference type and improvement

Static Characteristics of the Air Gauging Sensor Applied in the Microhole Measurement

A Porous Media Leakage Model of Contact Mechanical Seals Considering Surface Wettability

A New Method to Establish Coupled Multi-Physics Model of Lubricated Pin-Hole Oscillating Pair

Investigation of Potting-Adhesive-Induced Thermal Stress in MEMS Pressure Sensor

Development of Double-Insulated Ring Sensors for Hollow Pin Preload Measurement

Gas slug parameter measurement based on double embedded U-tube electromagnetic wave phase sensor in gas-liquid slug flow

Measurement System and Evaluation Approach for Straightness Error of Valve Sleeve Inner Hole

Fault mechanism and dynamic two-phase flow behavior of liquid slugging in reciprocating compressors

Interface Leakage Theory of Mechanical Seals Considering Microscopic Forces

The Theoretical and Experimental Investigation on the Vertical Magnetic Fluid Pressure Sensor