Abstract:The wide concern on absolute pressure calibration of acoustic transducers at low frequencies prompts the development of the pistonphone method. At low frequencies, the acoustic properties of pistonphones are governed by the pressure leakage and the heat conduction effects. However, the traditional theory for these two effects applies a linear superposition of two independent correction models, which differs somewhat from their coupled effect at low frequencies. In this paper, acoustic properties of pistonphones at low frequencies in full consideration of the pressure leakage and heat conduction effects have been quantitatively studied, and the explicit expression for the generated sound pressure has been derived. With more practical significance, a coupled correction expression for these two effects of pistonphones has been derived. In allusion to two typical pistonphones, the NPL pistonphone and our developed infrasonic pistonphone, comparisons were done for the coupled correction expression and the traditional one, whose results reveal that the traditional one produces maximum insufficient errors of about 0.1dB above the lower limiting frequencies of two pistonphones, while at lower frequencies, excessive correction errors with an explicit limit of about 3dB are produced by the traditional expression. The coupled correction expression should be adopted in the absolute pressure calibration of acoustic transducers at low frequencies. Furthermore, it is found that the heat conduction effect takes a limiting deviation of about 3dB for the pressure amplitude and a small phase difference as frequency decreases, while the pressure leakage effect remarkably drives the pressure amplitude to attenuate and the phase difference tends to be 90° as the frequency decreases. The pressure leakage effect plays a more important role on the low frequency property of pistonphones.

A Study on the Pressure Leakage Correction of Pistonphones at Infrasonic Frequencies

Analysis of the Sound Pressure in Membrane-Sealed Pistonphone

Nonlinear Distortion Characteristic Analysis for the Finite Amplitude Sound Pressures in the Pistonphone

Acoustic Properties of Pistonphones at Low Frequencies in the Presence of Pressure Leakage and Heat Conduction

A Reference Infrasound Source with Low Distortion Based on Laser Pistonphone Technology

Study on measurement technology of dynamics characteristics of typical tubes for pressure measurements

A Study on Finite Amplitude Standing Waves in Stepped Acoustic Resonator

A Dedicated Pistonphone for Absolute Calibration of Infrasound Sensors at Very Low Frequencies

Study on Nonlinear Acoustic Waves in Stepped Acoustic Resonators

Investigation of sound pressure leakage effect for primary calibration down to 10 -2 Hz using a laser pistonphone system

Analysis of force and leakage in water hydraulic motor' s piston pairs

Investigation on standing-wave thermoacoustically driven RC load with a pressure amplifier

The Mechanism of Errors Generated from Slug Inside Pinhole in Pressure Measurement

Research on Pressure Measurement Model Using Surface Wave Considering Temperature Effect

Impact of Pressure Difference on Leakage Rate from Rigid Positive Standard Leak:A Theoretical and Experimental Study

Pressure Sensor Based on the Time-Interval Between Neighboring Longitudinal Waves

A New Nondestructive Technique for Measuring Pressure in Vessels by Surface Waves

Leakage Characteristic Identification of Labyrinth Seals on Reciprocating Piston Through Transient Simulations

A Study on Thickness Optimization of Porous Material in Hybrid Sound Absorbing Systems with Pressure-Release Method

A calculation and uncertainty evaluation method for the effective area of a piston rod used in quasi-static pressure calibration

A method for correcting the high-frequency mechanical vibration effects in the dynamic calibration of pressure measurement systems using a shock tube