Abstract:A new nondestructive pressure-measurement method that can avoid potential safety problems caused by applying traditional pressure-measurement methods in vessels is presented. This method utilizes ultrasonic Rayleigh waves and critically refracted longitudinal waves ( L CR waves). The change in pressure induces a change in the stresses in the vessel's wall. According to the acoustoelastic principle, variations in stress affect the wave velocity. Meanwhile, the velocity of ultrasonic waves can also be affected by the change in temperature. Considering the effect of the pressure and temperature of the vessel on both the wave velocity and propagation distance of the ultrasonic waves, the relationship between ultrasonic transit time delay and both the pressure and temperature change is established. Furthermore, a modified model of pressure measurement is deduced. With this model, a reference method for temperature compensation, without temperature measurement, is presented. The reference method utilizes Rayleigh waves and L CR waves. These two kinds of ultrasonic waves travel along the axial direction of the vessel's wall, bearing the same changes in pressure and temperature. The relationship between the reference transit time delay between two ultrasonic transducers and the pressure is established through theoretical analysis and calibration tests on an air vessel. To reduce the error caused by the unevenness of temperature distribution, which might occur in the vessel's and the transducer's material, a new kind of transducer is used in the experiment, which has two piezoelectric elements and can be used for the Rayleigh and L CR waves. A pair of such transducers is mounted along the axial direction of the air vessel. The penetration area of the Rayleigh wave is almost the same as that of the L CR wave with the use of the new transducers. Comparison tests between the new transducers and the custom-used transducers show that the new transducers have better repeatability. Finally, using the air vessel as a specimen, experimental results show that the reference method is effective and that the pressure values calculated using the reference method are close to the manometer-measured values.

Research on Pressure Measurement Model Using Surface Wave Considering Temperature Effect

A New Nondestructive Technique for Measuring Pressure in Vessels by Surface Waves

Measurement of surface temperature and pressure of thin-walled vessels based on Rayleigh wave

Nondestructive Pressure Measurement in Vessels Using Rayleigh Waves and <formula> <tex>$l_{\rm CR}$</tex> </formula> Waves

Nondestructive Pressure Measurement in Vessels Using Rayleigh Waves and L-Cr Waves

Model Tests and Parametric Analysis on Pore Pressure Response in Silty Clay Seabed under Vertical Caisson Breakwater

A new method for nondestructively measuring pressure based on the Rayleigh wave

Study on measurement technology of dynamics characteristics of typical tubes for pressure measurements

Pressure Measurement Based on Multi-Waves Fusion Algorithm

A Numerical Study on the High-Velocity Impact Behavior of Pressure Pipes

Ultrasonic Pressure Measurement in Pressure Vessels

A Model-Based Transit-Time Ultrasonic Gas Flowrate Measurement Method

Research on Air Pressure Compensation System for Transducer Underwater

Study on the High Precision Acoustic Measurement Techniques for Determining Temperature Field Around Seafloor Hydrothermal Vent

Ultrasonic Measurement of Stress Considering Strain Effect

Pressure Sensor Based on the Time-Interval Between Neighboring Longitudinal Waves

Pressure Measurement System Using Surface Wave Based on TDC

Investigation of the Pressure Probe Properties As the Sensor in the Vortex Flowmeter

Model Analysis and System Parameters Investigation for Transient Wave in a Pump–Pipe–Valve System

Stress Measurement of a Pressurized Vessel Using Ultrasonic Subsurface Longitudinal Wave With 1-3 Composite Transducers

A Non-Intrusive Pressure Sensor by Detecting Multiple Longitudinal Waves