Abstract:The large-capacity three-phase brushless exciter, constituted by multi-branch armature winding generator and the bridge rectifier, usually operates under 'diode-parallel structure' or 'rectifier-parallel structure'. Ideally, currents of all paralleled diodes in the same bridge leg or branch currents of the same phase should be equal in normal operation. However, due to inconsistence of the diodes parameters and errors of generator manufacture, currents of the paralleled components are always different in practice. Even in normal operation, there are some certain inherent unbalanced currents among the paralleled components. This paper presents a study on the inherent unbalanced currents in the large-capacity three-phase brushless exciter. Two experimental platforms, called diode-parallel system and rectifier-parallel system, are built up one after another, with the same threephase dual-branch synchronous model machine and the samebatch diodes. It is found that the corresponding diode currents in the two systems, which should be equal in ideal condition, are significantly different in real systems. Neither frequencies nor effective values of the inherent unbalanced currents in the two systems are the same. Mechanism of the phenomenon is explained based on analysis of the electromotive force and circuit of the unbalanced current. Finally, combining the theoretical analysis with FFT results of experiment data, advantages and disadvantages of two systems are clarified. The inherent unbalanced currents in the rectifier-parallel structure are smaller than those in the diode-parallel structure, which results in a relative lower requirement for the diodes. The work in this paper could provide a basis for topology selection of large-capacity three-phase multi-branch brushless exciter system.

Fault Analysis and Relay Protection Principle for Multi-phase Ring Brushless Excitation System of Nuclear Power

Research on the Fault Diagnosis Method for Slip Ring Device in Doubly-Fed Induction Generators Based on Vibration

Analysis of the Interturn Short Circuits of Stator Field Windings in Multiphase Angular Brushless Exciter at Nuclear Power Plant

Analysis of Armature-Winding Inter-Turn Short Circuit Fault in Multiphase Brushless Exciter

Diagnosis of Rotor Winding Short-Circuit Fault in Multi-Phase Annular Brushless Exciter Through Stator Field Current Harmonics

Modeling, Analysis, and Identification of Armature Winding Interturn Fault in Multiphase Brushless Exciters

THE ANALYSIS OF THE MULTI-PHASE EXCITING GENERATOR OPERATING IN FAULT STATE

Modeling and Evaluation of Stator and Rotor Faults for Induction Motors

Analysis of Armature Winding Open‐phase Fault in Multi‐phase Annular Brushless Exciter at Nuclear Power Plant

Simulation and recognition for rotary rectifier fault of multi-phase brushless excitation system

Exciter stator current harmonics of multi-phase brushless excitation system

Internal Fault Analysis and Optimization Design of Main Protection Scheme for Shanghai Electric Phase Modifier

Improvement of overcurrent protection for control rod drive mechanism power system

A novel protection scheme for two-phase faults in power distribution system with neutral ungrounded

Online Identification Methodology of Field Winding Short Circuit Fault of Turbogenerator

Analysis of Stator Internal Phase-to-Phase Short Circuit Between Different Bridge-Rectifiers in the 12-Phase Synchronous Generator With Rectifier-Load System

Internal Fault Analysis and Optimization Design of Main Protection Scheme for Large Condenser

A study of armature winding internal faults and protection schemes for turbogenerators

New Development of Protection Technique for Electric Main Equipment

Analysis of Inherent Unbalanced Currents in Three-Phase Multi-Branch Brushless Exciter

THE INTERNAL FAULT ANALYSIS AND PROTECTION SCHEME OF THE TURBOGENERATOR ARMATURE WINDINGS