Abstract:In dual three-phase surface-mounted permanent magnet (PM) machines, three-phase short circuit (3PSC) fault is usually assumed to happen in only one winding group whilst the remaining one can be normally supplied. This article investigates the influence of healthy winding group (HWG) current on 3PSC of faulty winding group (FWG) and the resulting demagnetization. Firstly, the article develops the analytical model of 3PSC current component caused by HWG current. Based on this, the influence of HWG current is analyzed. It is found that, for symmetrical winding configurations, the d- and q-axis peak 3PSC current can be reduced to their minimum values when HWG current angles are about 90 and 135 electrical degrees, respectively. In addition, the suppression is more effective when HWG current amplitude increases. However, for asymmetric winding configurations, the suppression effect heavily depends on 3PSC start rotor position. The optimal HWG current angles are given for different start rotor positions, which maximumly reduces the d-axis peak current and demagnetization. Then, this article investigates the influence of forcing HWG into 3PSC on peak short-circuit current. It is found that an additional inductance component is added in FWG when forcing HWG into 3PSC, which reduces the peak current. However, since 3PSC current in HWG can also lead to demagnetization, the overall demagnetization level can be mitigated only at relatively low PM temperatures. Finally, experiments are conducted to validate the theoretical analysis.

Analysis of Armature Winding Open‐phase Fault in Multi‐phase Annular Brushless Exciter at Nuclear Power Plant

Modeling, Analysis, and Identification of Armature Winding Interturn Fault in Multiphase Brushless Exciters

Analysis and Mitigation of Fault-Induced Electromagnetic Force Effect on PM Modules in Integral-Slot Wind Generators

Solution of Permanent Magnet Synchronous Motors with Partition between Poles Halbach Magnet

Analysis of Armature-Winding Inter-Turn Short Circuit Fault in Multiphase Brushless Exciter

Analytical Modeling and Analysis of Open-Circuit Magnet Loss in Surface-Mounted Permanent-Magnet Machines

Influence of Healthy Winding Group Current on Three-Phase Short-Circuit and Demagnetization in Dual Three-Phase Surface-Mounted PM Machines

Analysis of the Interturn Short Circuits of Stator Field Windings in Multiphase Angular Brushless Exciter at Nuclear Power Plant

Diagnosis of Rotor Winding Short-Circuit Fault in Multi-Phase Annular Brushless Exciter Through Stator Field Current Harmonics

Fault Analysis and Relay Protection Principle for Multi-phase Ring Brushless Excitation System of Nuclear Power

Analysis of Armature Winding Internal Faults and Design of Main Protection Scheme for Synchronous Generators

Harmonic Model and Remedy Strategy of Multiphase PM Motor under Open-Circuit Fault

THE ANALYSIS OF THE MULTI-PHASE EXCITING GENERATOR OPERATING IN FAULT STATE

Preparation Analysis of the Overall Characteristics for High Power PMSM with Multi Phase Units

Internal Fault Analysis and Optimization Design of Main Protection Scheme for Shanghai Electric Phase Modifier

Online Identification Methodology of Field Winding Short Circuit Fault of Turbogenerator

Research on magnetic field and temperature field of multi-phase SPMSM under winding fault

Analysis of Armature Inter-Turn Fault in the Multiphase Synchronous Generator-Rectifier System

A study of armature winding internal faults and protection schemes for turbogenerators

Investigation of a Parallel Hybrid Excitation Machine with Auxiliary Winding for Loss Reduction in Flux-Weakening Operation

Influence of Inter-turn Short-Circuit Fault Considering Loop Current on Electromagnetic Field of High-Speed Permanent Magnet Generator with Gramme Ring Windings