Abstract:The large-capacity three-phase brushless exciter, constituted by multi-branch armature winding generator and the bridge rectifier, usually operates under 'diode-parallel structure' or 'rectifier-parallel structure'. Ideally, currents of all paralleled diodes in the same bridge leg or branch currents of the same phase should be equal in normal operation. However, due to inconsistence of the diodes parameters and errors of generator manufacture, currents of the paralleled components are always different in practice. Even in normal operation, there are some certain inherent unbalanced currents among the paralleled components. This paper presents a study on the inherent unbalanced currents in the large-capacity three-phase brushless exciter. Two experimental platforms, called diode-parallel system and rectifier-parallel system, are built up one after another, with the same threephase dual-branch synchronous model machine and the samebatch diodes. It is found that the corresponding diode currents in the two systems, which should be equal in ideal condition, are significantly different in real systems. Neither frequencies nor effective values of the inherent unbalanced currents in the two systems are the same. Mechanism of the phenomenon is explained based on analysis of the electromotive force and circuit of the unbalanced current. Finally, combining the theoretical analysis with FFT results of experiment data, advantages and disadvantages of two systems are clarified. The inherent unbalanced currents in the rectifier-parallel structure are smaller than those in the diode-parallel structure, which results in a relative lower requirement for the diodes. The work in this paper could provide a basis for topology selection of large-capacity three-phase multi-branch brushless exciter system.

Exciter stator current harmonics of multi-phase brushless excitation system

Transient Analysis Of Synchronous Generator With Stator Winding Faults Based On Starting Process

Diagnosis of Rotor Winding Short-Circuit Fault in Multi-Phase Annular Brushless Exciter Through Stator Field Current Harmonics

Calculation of the main parameters of induction machines under rotor winding faults

Modeling and Evaluation of Stator and Rotor Faults for Induction Motors

Simulation and recognition for rotary rectifier fault of multi-phase brushless excitation system

Analysis of the Interturn Short Circuits of Stator Field Windings in Multiphase Angular Brushless Exciter at Nuclear Power Plant

Analysis of Inherent Unbalanced Currents in Three-Phase Multi-Branch Brushless Exciter

Online Identification Methodology of Field Winding Short Circuit Fault of Turbogenerator

Fault Analysis and Relay Protection Principle for Multi-phase Ring Brushless Excitation System of Nuclear Power

Fault Diagnosis of a Rotating Rectifier in a Wound-Rotor Synchronous Starter/Generator in the Generation Mode

Detection of Stator Winding Faults in PMSMs Based on Second Harmonics of Phase Instantaneous Reactive Powers

Analysis of Armature-Winding Inter-Turn Short Circuit Fault in Multiphase Brushless Exciter

Modeling, Analysis, and Identification of Armature Winding Interturn Fault in Multiphase Brushless Exciters

THE ANALYSIS OF THE MULTI-PHASE EXCITING GENERATOR OPERATING IN FAULT STATE

Stator Inter-Turn Fault Detection in Closed-Loop Controlled Drive Based on Switching Sideband Harmonics in CMV

Stator inter-turn fault detection for the converter-fed induction motor based on the adjacent-current phase-shift

High-Frequency Voltage Injection-Based Fault Detection of a Rotating Rectifier for a Wound-Rotor Synchronous Starter/Generator in the Stationary State

Diagnosis of Stator Faults in Induction Motor Based on Zero Sequence Voltage after Switch-off

Harmonic Model and Remedy Strategy of Multiphase PM Motor under Open-Circuit Fault

Design and Analysis of a Static Excitation Part of a Brushless Wound Rotor Excitation Synchronous Machine Without an Exciter