Optical arrangement method of lighting units in switchgear based on partial discharge luminosity distribution characteristics

MIAO Jin,CHEN Ping,LENG Zhaoyun,REN Ming

DOI: https://doi.org/10.12067/ateee2206035

2023-01-01

Abstract:Partial discharge photometry has the characteristics of high sensitivity and strong anti-interference, but its detection effect is greatly affected by the deployment position of the sensor. Therefore, based on the radiation characteristics and transmission characteristics of the optical signal itself, the optimal design of the deployment position of the sensor in the device is carried out. In this paper, an optimal arrangement scheme of switchgear lighting units based on the characteristics of partial discharge luminosity distribution is proposed. A discharge weak light detection device based on SiPM sensor was designed, and the corresponding relationship between the optical detection performance of the device and the apparent discharge was determined by using the integrating sphere. The results show that for the discharge with an apparent discharge amount of 154.9 pC, the discharge detection can be realized after the sensor device measures more than 0.022 5% of its light energy. After that, an optical simulation model of the switchgear cable room was established, and a discharge light source was set at the typical fault location. According to the optical simulation results, the sensor is selected to arrange the sensor at a position that can obtain higher response intensity for different discharge light sources. The results show that the sensor can effectively detect the discharge at the selected installation location.