Abstract:As process technologies advance into deep sub-micrometer and nanometer scale, the charged device model (CDM) is now considered an important stress model for defining electrostatic discharge (ESD) reliability of integrated circuits. Thus the turn-on time of the ESD elements used in the protection circuit becomes important. At this time, there is no good method to evaluate the CDM ESD device turn-on speed. Equipment like VF-TLP and CC-TLP are too complicated and not precise for this purpose. A new method to evaluate the ESD device turn-on speed is presented in this paper. Based on this novel approach, some CDM ESD devices are analyzed based on the transmission line pulsing (TLP) tester. The designed devices include diodes, grounded-gate NMOS, SCRpsilas (silicon controlled rectifier), and Modified-Lateral SCRpsilas (MLSCR). The rising time of the pulse is set at 200 psec to accurately simulate real CDM pulses. The time-dependent voltage and current data are extracted and calculated from each pulse in the Time Domain Reflection (TDR) TLP tester. Two new ESD turn-on conditions are proposed and defined based on the transient currents in order to compare the relative speed of different ESD devices. The results show that the normalized turn-on time of different devices with various sizes and finger numbers do not correlate well with that obtained under the normal DC conditions, and the same device shows different turn-on characteristics under different pulses. These results enable devices to be designed for improved CDM ESD protection levels, and the present method can be used for ESD design for future nanometer technologies.

Test Methods for Performance of Protective Devices Excited by Conducted Transient Electromagnetic Disturbance

Transient Analysis of Transmission Lines Loaded by Active Devices Illuminated by an Electro-Magnetic Pulse in the Indoor Environment

A Test Method for Response Behavior of Metal-Oxide Arrester Subjected to Transient Electromagnetic Disturbances

Selection of Protection Measure for Very Fast Transient Overvoltage of 500 Kv GIS

Investigation of Turn-on Speeds of Electrostatic Discharge Protection Devices Using Transmission-Line Pulsing Technique

Analyse of Protection Devices' Speed Performance against ESD under CDM Using TCAD

Research on Protection Performance of Surge Protective Devices against Electromagnetic Pulse

Response Time Test for Low Voltage Lightning Protection Device

A Novel Single-ended Transient-based Boundary Protection Based on the Instantaneous Energy of Traveling Waves

A Novel and Powerful TCAD Methodology to Evaluate Performance of ESD Protection Devices

Disturbance Rejection Degree and Countermeasures to the Disturbance of Electric Fast Transient Pulse Caused by Relays

An Integrated Testbed with Single DC Source for Delivering Symmetrical Square-Wave Excitation Voltage in the Triple Pulse Test.

Strong Electromagnetic Pulse Interference Loading Method on Electrical Equipment under Operation State

Current Interruption Tests of HVDC Circuit‐breakers: Requirements, Methods and a Testing Case

A Comprehensive Approach for Transient Performance of Grounding System in the Time Domain

Key techniques of transient signal generator for test of traveling wave protection

Response of 10-Kv Metal-Oxide Surge Arresters Excited by Nanosecond-Level Transient Electromagnetic Disturbances

Test Method for Transient Characteristics of Grounding Grid with Current Return Point Located in the Same Grid

Quantitative Determination Of Response Time And Time-Varying Characteristics Of Surge Protective Devices

Test Method for Lightning Response of Real Transmission Lines

Analysis on Electromagnetic Compatibility Immunity Requirements for Transfomers During Switching Transient Operations in UHV GIS Substation