Abstract:High-altitude electromagnetic pulse (HEMP) has attracted considerable attention for its influence on electrical equipment. HEMP is divided into three parts: early time HEMP (E1), intermediate-time HEMP (E2), and late-time HEMP (E3). Most studies focused on E1 alone, while few investigated others. However, the electrical equipment may be disturbed by more than one part since these three parts co-exist in a HEMP environment. The pulse current injection (PCI) test is an effective immunity test method for evaluating the sensitivity and susceptibility of electrical equipment. To investigate the responses of electrical equipment excited by the consecutive E1 and E2 and compare with those under the individual E1 or E2, this paper builds a PCI platform that can carry out PCI tests with the consecutive E1 and E2 conducted current. To output the E1 current and the E2 current consecutively, which exhibit significant differences in the rise time (20 ns and 1.5 mu s), peak current (2500 and 250 A), and full width at half maximum (FWHM, 500-550 ns and 3-5 ms), an E1&E2 coupler with a fast-closing high-current trigger switch is designed in this paper. Finally, some 10-kV epoxy insulators are tested in the developed platform, which shows the capacity of the proposed platform to test the immunity of electrical equipment with the consecutive E1 and E2 conducted current.

Strong Electromagnetic Pulse Interference Loading Method on Electrical Equipment under Operation State

Pulse Current Injection Platform with Consecutive Early-Time and Intermediate-Time High-Altitude Electromagnetic Pulse Conducted Currents for Immunity Test of Electrical Equipment.

Research on High-Power Electromagnetic Effect and Protective Technology of Electronic Equipments

Investigation on Time- and Frequency-Domain Responses of Some Complex Composite Structures in the Presence of High-Power Electromagnetic Pulses

Electro-Thermo-Mechanical Characterizations of Various Wire Bonding Interconnects Illuminated by an Electromagnetic Pulse

Electromagnetic Immunity Performance of Intelligent Electronic Equipment in Smart Substation’s Electromagnetic Environment

Transient Analysis of Transmission Lines Loaded by Active Devices Illuminated by an Electro-Magnetic Pulse in the Indoor Environment

Investigation on conductive electromagnetic pulse (EMP) effects on the breakdown of GaAs MESFET-built power amplifiers (PA)

Enhanced conformal FDTD method for predicting transient responses of arbitrary PEC wedges illuminated by an electromagnetic pulse

High altitude nuclear electromagnetic pulse waveform standards: a review

10-kV Transmission Line Experimental Platform for HEMP Immunity Test of Electrical Equipment in Operation

Damage Effect of Typical Electronic Device under EMP

Numerical Simulation of the Intermediate-Time High-Altitude Electromagnetic Pulse

Study of measurement techniques for strong pulsed electric field

Methodical Approach for Immunity Assessment of Electronic Devices Excited by High Power EMP

Power System Damage Assessment Considering Cascading Failures under the E1 HEMP

Environment of EMP conducted disturbance and immunity test methods

Eletromagnetic Interference of Transmisssion Line in HEMP Environment

Research on the Equivalent Impact Test Method for Different Pulse Widths Based on Micro-Electro-Mechanical System Devices

A Compact High Voltage Pulse Generator for Bounded-wave EMP Simulator

Research on Anti-strong Electromagnetic pulse Technology for Power Port of Land Warfare Platform