Abstract:Microchannels are widely used for heat transfer enhancement. The pressure characteristics are one of the most important factors affecting the heat transfer performance, and the pressure regulation may also control the heat transfer precisely in turn. As a common flow pattern of two-phase flow, slug flow has obvious advantages for heat and mass transfer, like steady flow rate and large interface area etc. Due to the interface stress and the velocity difference between the continuous phase and the dispersed phase, pressure fluctuations occur in both the flowing direction and the cross section. In oil and natural gas industries, pressure fluctuations of slug flow can be used for the slug size and velocity measurement, and also to analyze the principle of slug generation. However, when it comes to micro scale, pressure fluctuations of slug flow in microchannels is difficult to measure, not only due to the pressure difference within a low pressure range (10 to 103 Pa), but also because of the small size, for which conventional pressure sensors cannot be utilized. In this paper, a numerical method is adopted for the liquid-liquid slug flow (butanol/water) pressure prediction in a cross-junction square microchannel. To begin with, the validation of the numerical method is carried out by comparing the slug size with experiments under the same working conditions. Then, both pressure fluctuations in the flow direction and in the cross section are investigated. With a transient flow model, pressure fluctuations in the cross section at different flowing time are observed. Finally, effects of the dispersed phase (butanol) injection velocity on pressure fluctuations are performed. This work can be used for further study of the slug generation in microchannels. (Less)

Nature and Characteristics of Gas–liquid Flow Regimes in a Micro‐packed Bed Reactor

Local and global gas-liquid mass transfer in a micro-packed bed reactor utilizing a noninvasive colorimetric technique

Liquid holdup of gas–liquid two‐phase flow in micro‐packed beds reactors

Mixing Effects on the Gas Flow and Mass Transfer in a Vertical Single Helical Ribbon Agitated Reactor for Propylene Polymerization

PRESSURE FLUCTUATIONS OF LIQUID-LIQUID SLUG FLOW IN CROSS-JUNCTION SQUARE MICROCHANNELS

Flow Regime Transition and Liquid Distribution in a 3D Concurrent Downflow Three-Phase Moving Bed

The gas–liquid mass transfer and pressure drop behaviors of the gas–liquid–liquid three‐phase flow in micro‐packed beds

Hydrodynamics and mass transfer of gas–liquid flow in micropacked bed reactors with metal foam packing

Study on Hydrodynamics and Mass Transfer Characteristic of a New Gas-liquid Reactor

Experimental Investigation on Submerged Gas-Liquid Mixture Injection into Water Through A Micro-Channel

Impact of the Channel- to Particle-Diameter Ratio on the Liquid-Liquid Mass Transfer and Pressure Drop in Micro Packed Bed Reactors

Investigation of Effective Interfacial Area in Micropacked Bed Reactors

Effect of Mixing on Mass Transfer Characterization in Continuous Slugs and Dispersed Droplets in Biphasic Slug Flow Microreactors

Gas–liquid–liquid Slug Flow and Mass Transfer in Hydrophilic and Hydrophobic Microreactors

Hydrodynamics and Model of Gas‐liquid Flow in Microbubble Column Reactors

Dispersion behavior of liquid–liquid and gas–liquid two‐phase flow in micro‐packed beds

Hydrodynamics and Local Mass Transfer Characterization under Gas–liquid–liquid Slug Flow in a Rectangular Microchannel

Hydrodynamics and Mass Transfer Performance of Gas–liquid Microflow in Viscous Liquids

A General Pressure Drop Model Based on Liquid Holdup of Gas-Liquid Flow in Micro-Packed Beds

Mass transfer mechanism and relationship of gas–liquid annular flow in a microfluidic cross-junction device

Hydrodynamics and liquid–solid mass transfer in micropacked bed reactors with copper foam packing