Abstract:Si80Ge2-xSbx based alloys were synthesized employing high energy ball milling and induction hot pressing with change in milling time and Sb content. With increasing milling time, the grain size decreases and the elements become more evenly distributed for both the as-milled powder and the hot pressed samples. Microstructure analysis on the hot pressed samples revealed presence of nano-features of 10-200 nm and existence of multiphases, including Si-rich matrix, Ge-rich phase and Si-Ge-Sb ternary precipitates. Moreover, for the dry-milled samples the intended doping element, Sb, prefers to locate in the Ge-rich phase or in the Si-Ge-Sb ternary area rather than in the Si-rich matrix. Sb doping leads to n-type conduction, but Sb content has little influence on the carrier concentration. The milling time has double effects on the thermoelectric properties. On the one hand, the inhomogeneous dopant distribution in the samples prepared by shorter milling time leads to higher carrier mobility and higher power factor due to modulation doping effect. But on the other hand, the thermal conductivity decreases with increasing milling time due to enhanced boundary scattering of middle-to-long term phonons at the nano-to-micro sized boundaries and impurity interfaces. As a result, the 2 h dry-milled and hot pressed sample obtains the maximum power factor of 2.5 x 10(-3) Wm(-1) K-2 at 780 K, the more homogeneous samples prepared by 16 h of dry-milling or wet-milling exhibit the lowest power factor and lowest ZT, while the 6 h dry-milled and hot pressed sample with nominal composition Si80Ge18Sb2 possesses the maximum ZT value of 0.67 at 1000 K. (C) 2015 Elsevier Ltd. All rights reserved.

Preparation and Thermoelectric Properties of B-Doped p-Type SiGe Alloys

Thermoelectric Properties of Boron Doped SiGe Alloys by Ball Milling

Thermoelectric Performance of Si80Ge20−xSbx Based Multiphase Alloys with Inhomogeneous Dopant Distribution

Thermoelectric performance enhancement in p-type Si via dilute Ge alloying and B doping

Enhanced thermoelectric performance in n-type SrTiO3/SiGe composite.

High Thermoelectric Performance of Ge1−xPbxSe0.5Te0.5 Due to (pb, Se) Co-Doping

Simultaneously Enhanced Power Factor and Phonon Scattering in Bi0.4Sb1.6Te3 Alloy Doped with Germanium

Silicon-based thermoelectrics made from a boron-doped silicon dioxide nanocomposite

Thermoelectric properties of silicon germanium alloy nanocomposite fabricated by mechanical alloying and spark plasma sintering

Enhancement of thermoelectric performance in n-type Si90Ge10-based alloy by metallic Zn doping

Thermoelectric properties of n-type SiGe alloys with Sn incorporation

Synergetic enhancement of power factor and suppression of lattice thermal conductivity via electronic structure modification and nanostructuring on Ni and B co-doped p-type Si-Ge alloy

Enhanced thermoelectric performance of n-type Mg3Bi2-based materials by Se doping and alloying engineering

Optimized Carrier Concentration and Enhanced Thermoelectric Properties in GeSb4-xBixTe7 Materials

Realizing n-type gete through suppressing the formation of cation vacancies and bi-doping*

Enhanced Thermoelectric Performance in SmMg 2 Bi 2 via Ca-Alloying and Ge-Doping

Phase separation in bismuth doped Mg2Si0.5Ge0.5 thermoelectric alloy

Stabilizing the Optimal Carrier Concentration in Al/Sb-Codoped GeTe for High Thermoelectric Performance

Enhanced thermoelectric figure-of-merit in boron-doped SiGe thin films by nanograin boundaries

Modulating the Valence of Ga and the Deep Level Impurity for High Thermoelectric Performance of N-Type Pb0.98Ga0.02Te1-xSex Compounds

Thermoelectric enhancement of p-type Si <sub>80</sub>Ge <sub>20</sub> alloy via co-compositing of dual oxides: Respective regulation for power factor and thermal conductivity by β-Ga <sub>2</sub>O <sub>3</sub> and SiO <sub>2</sub> aerogel powders