Abstract:Solder is widely used in electronic packaging to connect die and substrate in die attach process. It is important to get a uniform solder distribution to provide good electrical conductivity, mechanical support as well as excellent thermal properties for packages, especially for power packages with high current densities. While nonuniform solder distribution would emerge when die moves and tilts in the reflow process due to the unbalanced capillary force induced by the liquidus solder. It would affect the solder reliability and the package life. In this paper, we investigated the geometry evolvement of large area lead-free solder paste used in power electronic packaging with Surface Evolver, and focused on the effect of die size and die tilt on solder reliability. Surface Evolver, an interactive program for the study of surfaces shaped by surface tension and other energies as well as subject to various constraints, was used to simulate the shape of solder. The quality of solder was then evaluated by finite element method (FEM) after evolvement. 2D meshes exported from Surface Evolver were imported to the FEA software for modeling. Thermal-structural analysis was conducted to study the thermal-mechanical performance of solder. As the large mismatch of coefficient of thermal expansion of solder, die and substrate, thermal expansion was considered. Simulations of different die sizes without die tilt were performed as control groups. Compared to the control groups, solder with die tilt suffers from higher inelastic strain and inelastic strain concentrates on the thinner side of solder. Both are adverse to the solder reliability. Larger die size would not only increase the inelastic strain on the corner of solder, but also induce larger die stress.

Influence of Solder on De-Embedded Capacitance

A Simple Solder-Free Fixture for Surface Mounted Device Measurement

Ground Plane Effect on the De-embedding Accuracy for Surface Mount Devices

A Deembedding Method for the S-Parameter Extraction of Surface-Mounted Devices with Asymmetric Fixtures

Capacitance Extraction of Three-Dimensional Interconnects Using Element-By-Element Finite Element Method (Ebe-Fem) and Preconditioned Conjugate Gradient (pcg) Technique

Electrothermal modelling of through silicon via (TSV) interconnects

The Influences of the Shaping Mould Design on the Performance of Capacitor and the Corresponding Countermeasure

An LC Resonant Method for the Accurate Extraction of Small Parasitic Resistance

Analysis of Smt Decoupling Capacitor Placement in Electronic Packages Using Hybrid Modeling Method

A Hybrid De-embedding Method for Low Loss and Reciprocal PCB Fixtures

Understanding the Impact of Surface Engineering, Structure, and Design on Electromigration Through Monte Carlo Simulation and In‐Situ SEM Studies

A Statistical Equivalent Circuit Modelling Based On Measured And De-Embedded S-Parameters

Capacitive coupling analysis of TSV array in 3D packaging

Effect of Die Size and Die Tilt on Solder Reliability under Thermal Cycling

Effect of bias potential and dimension on electrochemical migration of capacitors for implantable devices

"No-Clean" Flux Residues Detection With Impedance Measurements

The Influence of Solder on the Thermal Stress in a FCOL Device

Impact of Soldering Terminal Solderability of Component and PCB on Solder Joint Interface

A Study of Accurate Extraction of ESD Parasitic Capacitance

Wafer-Area-Saving Test Structures and Measurement Method for the Characterization of Interconnect Resistance and Capacitance in Nanometer Technologies

An in-situ experimental and simulation study on the electromigration behavior of SAC305 solder joints