Abstract:BACKGROUND: Phosphogypsum (PG) is a solid waste. For a fluidized bed, current research has focused on the preparation of CaO and SO2 by PG decomposition, while less research has been conducted with calcium sulfide (CaS) as the target product. Therefore, the effect of different conditions on the preparation of CaS by coal reduction of PG was investigated in a fluidized bed. The mechanism of the reaction between coal and PG was revealed through experiments and kinetic calculations. RESULTS: PG decomposition is a combination of solid-solid reaction (carbon reacting with CaSO4) and gas-solid reaction (reducing gas reacting with CaSO4), among which the solid-solid reaction plays a major role. A PG decomposition rate of 99.42% and CaS yield of 91.55% are obtained at 850 ?degrees C for 60 min when the Ca/C molar ratio is less than 0.25 and coal particle size is less than 0.075 mm. Lignite, bituminous coal and anthracite can promote the decomposition of PG. However, the higher viscosity of bituminous coal can lead to molten coking of the product, while anthracite is less economical, so lignite is the most suitable. Minerals in coal can improve the decomposition rate of PG. A fluidized bed improves the PG decomposition rate compared to a fixed bed. CONCLUSIONS: CaS is obtained by combined solid-solid and gas-solid reactions. Decreasing the Ca/C ratio and coal particle size as well as controlling the reaction temperature below 850 degrees C are beneficial for CaS generation. The minerals in coal can reduce the PG decomposition temperature and increase the PG decomposition rate. (C) 2022 Society of Chemical Industry (SCI).

Elemental Sulfur Recovery from FGD Gypsum and Calcium Cyclic Utilization in Coal-Fired Power Plants

Recovery elemental sulfur from calcium sulfide prepared by red gypsum in sulfuric acid wastewater treatment

Effective Recovery of Calcium and Sulfur Resources in FGD Gypsum: Insights from the Mechanism of Reduction Roasting and the Conversion Process of Sulfur Element

Performance evaluation of a gypsum-based desulfurizer for sulfur recovery from the smelter off-gas: Experimental analysis and thermodynamic performance

Calcination of Calcium Sulphoaluminate Cement Using Flue Gas Desulfurization Gypsum As Whole Calcium Oxide Source

Experimental Study of CaS Preparation from Lignite‐reduced Phosphogypsum in a Fluidized Bed

Hydrothermal Synthesis of Calcium Sulfate Whisker from Flue Gas Desulfurization Gypsum

UTILIZATION OF DRY AND SEMI-DRY FLUE GAS DESULFURIZATION RESIDUES

Resource utilization of semi-dry flue gas desulfurization ash by thermal treatment on sintering machine

Production of SO2 Gas: New and Efficient Utilization of Flue Gas Desulfurization Gypsum and Pyrite Resources

The Utilization of Fgd Gypsum for Removing Toxic Metals from Smelting Acid Wastewater Via Vulcanized Precipitate

Experimental Studies on Decomposing Properties of Desulfurization Gypsum in a Thermogravimetric Analyzer and Multiatmosphere Fluidized Beds

Preparation of calcium ferrite by flue gas desulfurization gypsum

Leaching Characteristics of Trace Elements in Desulfurization Gypsum from a Coal-Fired Power Plant

Phosphogypsum as a raw material for the production of SO2 and lime in circulating fluidized beds

Utilization of Desulfurization Gypsum to Producing SO2 and Cao in Multi-Stage Fluidized Bed

Study on a New Utilization Method for Dry and Semi-Dry Desulfurization FDG Residues

Chemical phase analysis of flue gas desulfurization gypsum powder

Research on Sulfur Recovery from the Byproducts of Magnesia Wet Flue Gas Desulfurization

Influence of Carbon and Pyrite on Desulfurization Behavior of Red Gypsum at High Temperature

Flue Gas Desulphurization Based on Limestone-Gypsum with A Novel Wet-Type Pcf Device