Abstract:Low- and high-Cu high-strength steels are designed and cast through strip and ingot casting. The results show that the Cu suppresses the formation of polygonal ferrite (PF) and intragranular acicular ferrite (IAF), but promotes the formation of granular bainite (GB) and bainite ferrite (BF). The microstructure is refined by the high cooling rate as indicated by the smaller width and length of acicular or lath ferrites for the strip casts. For the high-Cu strip cast, most Cu is retained in solid solution above equilibrium concentration due to the rapid secondary cooling rate. And the rest of Cu is found in the form of Cu-bearing precipitates, i.e ., duplex sulfide-oxide particle, shell-like sulfide, and Cu-rich precipitate. However, only duplex sulfide-oxide particle can be found in the low-Cu strip cast. Most of Mn is captured between the dendrites because of the rapid solidification, leading to an evident Mn microsegregation in the interdendritic region of the strip casts. It is found that the number density of nano-scale precipitates in both two strip casts is much lower than in ingot casts, which can be attributed to the incomplete precipitation caused by the rapid secondary cooling rate during strip casting. For either the low- or high-Cu high-strength steels, a higher tensile strength of the strip casts than the ingot casts results from solution strengthening, dislocation strengthening, and fine-grain strengthening. It is noted that the increasing of Cu content from 0.01 to 0.52 wt pct reduces the strength and total elongation of the ingot or strip casts, because the predominant microstructure of IAF turns into BF. Graphical

Effect of Copper on Microstructure and Properties of Cast Iron

Influence of Cu on Properties of High Strength Ductile Cast Iron

Effect of Manganese on Microstructure and Properties of Cast Iron

Effect of Cu addition on hardness and microstructural features of low alloy white cast iron

Effect of Aluminum, Copper and Manganese on the Structure and Properties of Cast Irons

Effect of Cerium on Microstructure, Texture and Properties of Ultrahigh-Purity Copper

Influence of Tungsten on Microstructure and Properties of As-Cast Hi-Cr Cast Iron

Effects of Cu Addition on the Microstructure and Properties of the Al–Mn–Fe–Si Alloy

Effect of Cu on Solidification Microstructure and Solidification Process in High Carbon High Speed Steel Type Cast Alloy

EFFECT OF COPPER ON MICROSTRUCTURE AND PROPERTY OF 00Cr25Ni7Mo4N STEEL

Effect of Cu Content on the Precipitation Behaviors, Mechanical and Corrosion Properties of As-Cast Ti-Cu Alloys

Microstructure Evolution and Mechanical Property of Cu-Bearing High-Strength Steel Produced by Simulated Strip Casting

Effect of Cu on the strengthening and embrittling of an FeCoNiCr-xCu HEA

The Effect of Boron (B) and Copper (Cu) on the Microstructure and Graphite Morphology of Spheroidal Graphite Cast Iron

Effect of Cu Content on Microstructure and Mechanical Properties for High-Strength Deposited Metals Strengthened by Nano-Precipitation

Effect of Copper and Nickel Content on the Corrosion Mechanisms in Ferritic Matrix Gray Cast Irons under Simulated Marine Environments

Effect of Copper Content and Heat Treatment Schedules on Mechanical Properties, Cold Resistance, and Microstructural Constituent Morphology in Precipitation-Hardened Steel

The Effect of the Cu Interlayer on the Interfacial Microstructure and Mechanical Properties of Al/Fe Bimetal by Compound Casting

Investigation of microstructure evolution and mechanical properties of near-eutectic Fe2-CoNiCr C high entropy cast iron

Tempering temperature dependence on the microstructure, mechanical properties and wear behaviour of a novel high chromium cast iron

Effect of Iron Fiber on the Properties of the Cu-Fe Composite