Abstract:This study presents the results of research on the influence of different contents of copper in aluminium alloys based on the 6xxx series on mechanical and structural properties. The investigation started with the alloying, and casting four billet variants with different copper content—0.8% Cu; 2B—1% Cu; 3A—1.2% Cu; and 3B—1.4% Cu. The prepared materials were homogenised and extruded on a 500T horizontal press with two different process temperatures and ram speeds ranging from 1 mm/s to 9 mm/s. After heat treating to the T6 and T5 tempers, their mechanical properties were tested. On this basis, the two most promising alloys 2A and 3B were selected and subjected to further tests. After extrusion and heat treatment of the profiles (to F, T1, T2, T5, and T5510), their mechanical properties were determined to select the preferred process parameters. Finally, a structural test based on crystallographic orientation based on the EBSD technique and TEM observations allowed for the characterisation of grain size, dispersoids, and phase analysis. Bright-field (BF) analysis allowed us to compare the deformed areas for T1, T5, and T5510 temperatures. The results showed significant growth in the mechanical properties of all the subjected alloys, and the best properties were shown for a Cu content of 1.4% with a tensile strength of 460 MPa and an elongation of 16% (T5510 tempering). The structural test showed an average grain size of 18 μm to 23 μm and solid solution decomposition differences for different heat-treating parameters.

Effect of Copper Content and Heat Treatment Schedules on Mechanical Properties, Cold Resistance, and Microstructural Constituent Morphology in Precipitation-Hardened Steel

Effect of heat treatment process on microstructure and properties of copper modified 1Cr11MoNiW1VNbN

Effects of evolution of nanoscale copper precipitation and copper content on mechanical properties of high-strength steel weld metal

Effect of Cu Alloying on Mechanical Properties of Medium-C Steel after Long-Time Tempering at 500 °C

The Influence of Heat Treatment on the Microstructure and Properties of a Cu-Bearing Ultra-Low Carbon Steel

Effect of Cu Content on Microstructure and Mechanical Properties for High-Strength Deposited Metals Strengthened by Nano-Precipitation

Effect of Heat Treatment on Mechanical Properties and Microstructure of Advanced High-Strength Steel

Effect of Cu on Solidification Microstructure and Solidification Process in High Carbon High Speed Steel Type Cast Alloy

Effect of Heat Treatment Parameters on the Microstructure of Quenching–partitioning–tempering Steel

Regulation of Cu Precipitation by Intercritical Tempering in A Hsla Steel

Strengthening Effect of Nanoscale Precipitation and Transformation Induced Plasticity in a Hot Rolled Copper-Containing Ferrite-Based Lightweight Steel

The Effect of Heat Treatment on Antibacterial Performance of High Strength Steel

Effect of heat treatment on microstructure and mechanical properties of S31042 austenite heat resistant steel

Effect of Cu content on the mechanical properties of an Al–Cu–Mg–Ag alloy

Effect of Temperature on Microstructure and Mechanical Properties of Fe-9Ni-2Cu Steel during the Tempering Process

Effect of Tempering Temperatures on Microstructure and Mechanical Properties of High-Strength Steel

Effects of Copper Content and Thermo-Mechanical Treatment on Microstructure and Mechanical Properties of AlMgSi(Cu) Alloys

Analyzing the Precipitation Effects in Low-Alloyed Copper Alloys Containing Hafnium and Chromium

Effect of Multistage Heat Treatment on Microstructure and Mechanical Properties of High-Strength Low-Alloy Steel

Importance of cold rolling and tempering on the microstructure evolution, precipitation behavior and mechanical responses of 9Cr3Co3W1Cu ferritic/martensitic steel

Effect of heat treatment on precipitation behavior of second phase and property evolution of martensitic stainless steel