Abstract:A discrete element method (DEM) model was developed for a co-rotating twin-screw mixer (TSM) consisting of conveying and kneading elements. This model was used to simulate the mixing of a cohesive binary system of particles (P1 and P2). The particles were calibrated using angle of repose and dynamic yield strength simulations. Properties of P1 were kept constant throughout the study while properties of P2 were varied. The TSM model was used to study the influence of particle size, density, and flowability of P2 on process outputs such as powder holdup, mean residence time (MRT), and degree of mixing along the length of the TSM. All the three particle properties were varied at three-factor levels with flowability ranging from good flow (GF), poor flow (PF), and very very poor flow (VVPF) based on Carr’s classification. The model provides fundamental insights into the differences in mixing in the conveying sections of the mixer for materials with different flowability. Due to the co-rotating nature of the screws, the majority of the material in the conveying sections was carried on one side of the TSM for GF and PF particles, while both the screws carried VVPF particles. The total steady-state holdup and the mean residence time (MRT) of particles inside the TSM were heavily influenced by particle flowability compared to the other two tested particle parameters. The holdup in the conveying compartments ranged from 11%–15% of the total holdup, while the kneading compartment comprised 40% of the total holdup in the mixer. The simulations found that VVPF particles mixed the fastest and that the GF particles had the highest tendency to demix. The model was also used to suggest and test other screw design configurations to improve mixing. A screw design with kneading elements closer to the mixer outlet resulted in better mixing of GF particles. A screw design consisting only of conveying elements achieved the same degree of mixing as the original screw design for VVPF particles.

Effects of Operating Conditions and Particle Properties on Mixing Performance in an Industrial-Scale U-shape Ribbon Mixer

Hydrodynamics and mixing process in a horizontal self-cleaning opposite-rotating twin-shaft kneader

Numerical Study on Particle Mixing in a Double-Screw Conical Mixer

Mixing Performance of Ribbon Mixers: Effects of Operational Parameters

Studying on the Upper Limit of the Coarse-Grained DEM Model for Simulating Mixing Processes in a Rolling Drum with Complex Wall Boundary

Discrete Element Analysis of the Particle Mixing Performance in a Ribbon Mixer with a Double U-shaped Vessel

Effects of operation parameters on particle mixing performance in a horizontal high shear mixer

An Experimentally Validated Coarse-Grain DEM Study of Monodisperse Granular Mixing

Effects of blade rake angle and gap on particle mixing in a cylindrical mixer

Discrete Particle Simulation for Mixing of Granular Materials in Ribbon Mixers: A Scale-Up Study

Research and Optimization Design of Mixing Characteristics of High-speed Centrifugal Mixer Based on DEM

Mixing Behaviour of Cohesive and Non-Cohesive Particle Mixtures in a Ribbon Mixer

Investigating the effects of material properties on the mixing dynamics of cohesive particles in a twin screw mixer using a discrete element method approach

Micromixing Simulation of Novel Large-Double-Blade Impeller

Numerical investigation of mixing and heat transfer of granular material in a ribbon reactor: effect of impeller speed and filling rate

Prediction of the Mixing Behaviour of Binary Mixtures of Particles in a Bladed Mixer

Flow and Mixing of Cohesive Particles in A Vertical Bladed Mixer

Enhancing Mixing of Particles by Baffles in A Rotating Drum Mixer

Evaluation of Mixing Process in Batch Mixer Using CFD-DEM Simulation and Automatic Post-Processing Method

Numerical Simulation of Particle Mixing Behavior in High Speed Shear Mixer and Cylinder Mixer

Influence of Particle Shape on Mixing Rate in Rotating Drums Based on Super-Quadric DEM Simulations