Abstract:Fundamental research on the flow and mixing of non-spherical particles is critical for industrial production and design. In this paper, the Discrete Element Method (DEM) is used to study the flow and mixing of granular materials in the horizontal rotating drum, and the periodic boundary condition is employed to eliminate end wall effect. Super-quadric elements are adopted to describe spherical and non-spherical particles. The influences of rotating speed, blockiness, and aspect ratio on the mixing rate are investigated by the Lacey mixing index. The results show that the rotating speed has a primary effect on the mixing rate, whereas the effect of the particle shape on the mixing rate is a secondary factor for non-spherical granular systems. Moreover, the mixing rate of spherical and non-spherical particle systems is significantly different. The mixing rate of spheres is the lowest, and the cubes have a higher mixing rate than the cylinders. As the blockiness decreases or aspect ratio deviates from 1.0, the mixing rate decreases. Ordered face-to-face contacts and dense packing structures result in a higher mixing rate. The analysis of kinetic energy shows that particle shape affects the transfer efficiency of external energy to the granular systems. The translational kinetic energy of non-spherical particles is higher than that of spherical particles, and their rotational kinetic energy is lower than that of spheres. Meanwhile, the blockiness enhances the transfer efficiency of external energy to the non-spherical systems; in contrast, the aspect ratio reduces the energy conversion efficiency. (C) 2020 The Society of Powder Technology Japan. Published by Elsevier B.V. and The Society of Powder Technology Japan. All rights reserved.

Effects of operation parameters on particle mixing performance in a horizontal high shear mixer

Hydrodynamics and mixing process in a horizontal self-cleaning opposite-rotating twin-shaft kneader

Nanoparticle Deagglomeration Driven by a High Shear Mixer and Intensification of Low-Speed Stirring in a Viscous System

Numerical Simulation of Particle Mixing Behavior in High Speed Shear Mixer and Cylinder Mixer

Numerical Study on Particle Mixing in a Double-Screw Conical Mixer

Studying on the Upper Limit of the Coarse-Grained DEM Model for Simulating Mixing Processes in a Rolling Drum with Complex Wall Boundary

Effects of Operating Conditions and Particle Properties on Mixing Performance in an Industrial-Scale U-shape Ribbon Mixer

Numerical Investigation of Mixing Performance for a Vertical Turbulence Mixer

Numerical Investigation on the Effect of the Particle Feeding Order on the Degree of Mixing Using DEM

Effects of blade rake angle and gap on particle mixing in a cylindrical mixer

Investigation of mixing homogeneity of binary particle systems in high-shear wet granulator by DEM

DEM Study of the Effect of Impeller Design on Mixing Performance in a U-shape Ribbon Mixer

Investigation the iron ore fine granulation effects and particle adhesion behavior in a horizontal high-shear granulator

Assessment of bi-disperse solid particles mixing in a horizontal paddle mixer through experiments and DEM

An Experimentally Validated Coarse-Grain DEM Study of Monodisperse Granular Mixing

The effect of impeller configurations on particle mixing in an agitated paddle mixer

Mixing Performance of Ribbon Mixers: Effects of Operational Parameters

Discrete Element Analysis of the Particle Mixing Performance in a Ribbon Mixer with a Double U-shaped Vessel

Mass transfer mechanism of multiphase shear flows and interphase optimization solving method

Research and Optimization Design of Mixing Characteristics of High-speed Centrifugal Mixer Based on DEM

Influence of Particle Shape on Mixing Rate in Rotating Drums Based on Super-Quadric DEM Simulations