Abstract:Based on the CM excitation voltage spectrum measurement and the electromagnetic‐simulated radiation transfer functions, an accurate prediction of the radiated emissions of a low‐power flyback adapter with complex cables is achieved. Radiated emissions (RE) testing has long been a challenge in the development of a switched mode power supply (SMPS) with respect to electromagnetic compatibility performance. Accurate far‐field RE prediction can effectively help SMPS designers reveal and understand the mechanisms of radiation generation, and reasonably suppress it. In this paper, a model for predicting the radiation from a single excitation source and a parasitic radiator for a flyback adapter are proposed after analysing the common mode voltage and current paths. Then, novel methods are proposed to predict the far‐field RE of the flyback adapter based on measurements and electromagnetic simulations. Using these methods, the 10‐m far‐field radiation of the flyback adapter under the curved cables layout is accurately predicted and verified by experiments. Then, the characteristics and influencing factors of the radiation are analysed, including the far‐field patterns, the load volume, and the sag degree of the output cable. Finally, a suppression design of the capacitor‐inductor (CL) notch filter is designed for the frequency points that are above the standard limits, and the RE are reduced to less than 30 dBμV/m from 30 to 300 MHz. The research methods proposed in this paper have good reference significance for radiation analysis and prediction of power electronic devices.

Radiated EMI Prediction in Power Converters with Power Cables Based on Cable Antenna Voltage Gain Extraction

Modeling and Prediction of Radiated Electromagnetic Interference for DC-DC Power Converter

Determining Far-Field EMI From Near-Field Coupling of a Power Converter

Far-Field Radiation Prediction and Analysis of a Power Converter with V-Shaped Flat Cables Based on PEEC

Far field radiated emissions prediction of a flyback adapter with curved cables utilizing electromagnetic simulation method

Modeling and Evaluation of Common-Mode EMI Coupling Through Converter Chassis in Metro Traction System

Prediction of Radiated Emissions from Cables over a Metal Plane Using a SPICE Model

Modeling and Prediction of Low-Frequency Near-Field Radiation for a Power Converter Based on the Operating Principle of a Monopole Antenna

Modeling of Common-Mode Current in Motor Cable of Inverter-Fed Motor Drive System

Mechanism Model and Prediction Method of Common Mode Radiation for a Nonisolated Very-High-Frequency DC–DC Converter with Cables

Electromagnetic Radiation Mechanism Analysis and Field Strength Prediction of an Elementary Digital Inverter with Cables

Common mode far field radiation mechanisms and prediction of a buck converter with cables based on common mode voltage mutation method

Investigation and Mitigation of Radiated EMI due to Near-field Coupling in a High-density Active-clamp Flyback Power Adapter

A Fast EMI Model Based on Equivalent Interference Sources in Medium-Voltage Cascaded H-Bridge System

The Electromagnetic Interference (EMI) affect on power supply of telecom equipment

Common-Mode Conducted EMI Prediction for Dual Active Bridge Converter Based on Unterminated Behavioral Model

Radiated Emission Prediction of a SMPS Based on Time Domain EMF-circuit Co-Simulation

A Novel Low-Frequency Radiated Emissions Prediction Technique for the Inductor of a Non-Isolated Power Converter

High-frequency modeling based EMC performance improvement of power supplies in inverters

Circuit Prediction Model of Electric Field Emission of a Vehicle-mounted Three-phase DC/AC Inverter

Prediction of Electromagnetic Radiation Emission from Telecommunication Power Supply