Abstract:Battery electric vehicles with multiple motors are characterized by actuator redundancy, which calls for application of instantaneously optimized distribution of motor/wheel torques, thus minimizing the energy consumption, i.e., maximizing the vehicle range. If the e-motors are equipped with disconnect clutches, the energy saving potential becomes even higher due to the avoidance of drag of inactive electric motors. However, in this case optimization through time and predictive control techniques should be used to provide globally minimal energy consumption. To this end, the paper proposes the following modeling, optimization, and model predictive control method for straight-line driving mode: (i) a dynamic backward-looking model of electric vehicle propelled by disconnect clutch-equipped four wheel motors, which takes into account the clutch synchronization-related drivetrain transient loss; (ii) globally optimal, dynamic programming (DP)-based off-line optimization of e-motor torque and clutch state control trajectories, and (iii) a model predictive torque vectoring control (MPC) strategy. The MPC strategy is verified by simulation for various certification driving cycles, and the results are compared with the DP-optimal benchmark for different values of a user-defined weighting coefficient, which penalizes frequent clutch disconnects for improved durability. The DP optimization results reveal that the energy consumption reduction achieved through the disconnect clutch functionality is up to 7%, on top of up to 5% reduction achieved by torque distribution itself. The MPC control strategy relying on the prediction horizon of 10 steps approach the DP energy consumption benchmark within the margin of 1%.

Transfer Case Clutch Modeling and EKF-UIO Based Torque Estimation Method for On-Demand 4WD Vehicles.

A Model-Based Temperature Estimation Method and Experimental Verification for 4WD Vehicle Transfer Case Clutch

Analysis of Clutch Engagement Judder and Its Influence Factors

Estimation of Transmitted Torques in Dual-Clutch Transmission Systems

Robust Hierarchical Estimator of Clutch Torques for a Compound Power-Split Hybrid Electric Vehicle

Dynamic coordinated control strategy of a dual-motor hybrid electric vehicle based on clutch friction torque observer

Development and evaluation of torque distribution methods for four-wheel independent-drive electric vehicle based on parameter estimation

Investigation on Adaptive Method of Torque Characteristic in Dual Clutch Transmission During Launch Phase

Simultaneous Estimation and Receding Horizon Sliding Control of Dog Clutch Coupling with Backlash for Rear Electrical Drivelines

Adaptive torque control of wet dual clutch based on dynamic friction coefficient estimation

A Hybrid Data-driven Soft Sensor Framework for Torque Estimation

On-demand 4WD Control of Electric Vehicles Based on Electric Disconnect Differential

Optimization of straight-line driving torque vectoring for energy-efficient operation of electric vehicles with multiple motors and disconnect clutches

An improved adaptive position tracking strategy for automatic shift actuator with uncertain parameters

Vehicle Tire Traction Torque Estimation Using a Dual Extended Kalman Filter

A Moment-of-Inertia-Driven Engine Start-Up Strategy for Four-Wheel-Drive Hybrid Electric Vehicles

Position-based impedance torque control for automatic clutch with robust predefined-time stability guarantee

Decoupling Internal Model Control for the Robust Engagement of Clutches

Estimation of the clutch pressure basing on reduced order model of the hydraulic actuator system

System dynamic modelling and adaptive optimal control for automatic clutch engagement of vehicles

Design of Torque Distribution Strategy for Four-Wheel-Independent-Drive Electric Vehicle