Abstract:Battery electric vehicles with multiple motors are characterized by actuator redundancy, which calls for application of instantaneously optimized distribution of motor/wheel torques, thus minimizing the energy consumption, i.e., maximizing the vehicle range. If the e-motors are equipped with disconnect clutches, the energy saving potential becomes even higher due to the avoidance of drag of inactive electric motors. However, in this case optimization through time and predictive control techniques should be used to provide globally minimal energy consumption. To this end, the paper proposes the following modeling, optimization, and model predictive control method for straight-line driving mode: (i) a dynamic backward-looking model of electric vehicle propelled by disconnect clutch-equipped four wheel motors, which takes into account the clutch synchronization-related drivetrain transient loss; (ii) globally optimal, dynamic programming (DP)-based off-line optimization of e-motor torque and clutch state control trajectories, and (iii) a model predictive torque vectoring control (MPC) strategy. The MPC strategy is verified by simulation for various certification driving cycles, and the results are compared with the DP-optimal benchmark for different values of a user-defined weighting coefficient, which penalizes frequent clutch disconnects for improved durability. The DP optimization results reveal that the energy consumption reduction achieved through the disconnect clutch functionality is up to 7%, on top of up to 5% reduction achieved by torque distribution itself. The MPC control strategy relying on the prediction horizon of 10 steps approach the DP energy consumption benchmark within the margin of 1%.

A Moment-of-Inertia-Driven Engine Start-Up Strategy for Four-Wheel-Drive Hybrid Electric Vehicles

A Moment-of-Inertia-Driven Engine Start-Up Method Based on Adaptive Model Predictive Control for Hybrid Electric Vehicles With Drivability Optimization

Optimal Engine Starts of an Input-Split Hybrid Electric Vehicle

Multi-objective real-time optimization energy management strategy for plug-in hybrid electric vehicle

Rule-Based Time-Optimal Engine-Start Coordination Control With a Predesigned Vehicle Acceleration Trajectory in P2 Hybrid Electric Vehicles

The Coordinated Control Strategy of Engine Starting Process in Power Split Hybrid Electric Vehicle Based on Load Observation

Analysis and Control of Engine Starting Process Based on a Novel Single-Motor Power-Reflux Hybrid Electric Vehicle

Dynamic Coordinated Control for a Full Hybrid Electric Vehicle with Single Motor

An Electric-Hydraulic Hybrid Wheel Loader with Mode-Driven Control Strategy

Adaptive Equivalent Consumption Minimization Strategy for Off-Road Hydraulic Hybrid Vehicles: A Cycle-to-Cycle Optimization Approach.

Coordinated Clutch Slip Control for the Engine Start of Vehicles with P2-hybrid Automatic Transmissions

Online Optimization of Pontryagin's Minimum Principle for a Series Hydraulic Hybrid Wheel Loader

Economical Launching and Accelerating Control Strategy for a Single-Shaft Parallel Hybrid Electric Bus

Optimization of straight-line driving torque vectoring for energy-efficient operation of electric vehicles with multiple motors and disconnect clutches

Active Damping Control of Start-up Process for Hybrid Vehicle

Torque Distribution Strategy for Multi-PMSM Applications and Optimal Acceleration Control for Four-Wheel-Drive Electric Vehicles

Hybrid Electric Vehicle Model Predictive Control Torque-Split Strategy Incorporating Engine Transient Characteristics

Dynamic coordinated control strategy of a dual-motor hybrid electric vehicle based on clutch friction torque observer

Dynamical model of HEV with two planetary gear units and its application to optimization of energy consumption

Hierarchical control for a full hybrid vehicle with single motor and double clutches

Innovative Design And Coordinated Control Of Multi-Mode Coupling Drive System With A Speed-Up Clutch For Plug-In Hybrid Electric Vehicles