Abstract:The temperature field of limited slip clutch (LSC) seriously interferes with torque transmission. In this paper, the attribute of dynamic partition of slip heat flux is considered. A calculation model of temperature field is also established by combining the proposed new method of fluid-solid equivalent convective heat transfer. The simulation and experiment of different relative speed, lubricant flow, and temperature are carried out. Furthermore, the comprehensive evaluation index of average temperature growth ratio and maximum radial temperature difference is proposed. The results show that the deviations of temperature rising rate and average temperature are not more than 0.2 °C/s and 6 °C, respectively. Heat flux partition value of separator plate increases approximately proportionally with relative speed. Changing relative speed from 40 r/min to 80 r/min, average temperature growth rate and maximum radial temperature difference of separator plate increase by 0.35 °C/s and 2.08 °C, respectively. On the contrary, increasing lubricant flow or reducing lubricant temperature weakens actual heat flux input of clutch. From 3 L/min to 10.5 L/min about lubricant flow, the average temperature growth rate and maximum radial temperature difference caused by higher relative speed are reduced by 0.32 and 2.71 °C, respectively. However, when lubricant temperature is adjusted from 65 °C to 30 °C, average temperature growth rate is reduced by 0.51 and the variation of maximum radial temperature difference does not exceed 0.32 °C. The research can accurately simulate actual energy flow at friction pair interface and assist in exploring the influence of condition parameters on temperature field.

A Model-Based Temperature Estimation Method and Experimental Verification for 4WD Vehicle Transfer Case Clutch

Prediction of the Temperature on AMT Clutch-disc Surface Based on LS-SVM

Design of Temperature Testing System in Multi-Parameter Combined Environmental Test

Transfer Case Clutch Modeling and EKF-UIO Based Torque Estimation Method for On-Demand 4WD Vehicles.

Experimental and Theoretical Analysis of the Drag Torque in Wet Clutches

Numerical and Experimental Research on Engagement Process of Wet Multi-Plate Friction Clutches with Groove Consideration

Simulation Research on the Drag Torque of Disengaged Wet Clutches

Finite Element Analysis for Temperature Field of Clutches Based on B-spline Wavelet

Simulation and Experiment on Dynamic Engagement Characteristics of Wet Clutch

Parametric Analysis of the Drag Torque Model of Wet Multi-Plate Friction Clutch with Groove Consideration

Analytical and Experimental Method of Thermal Load Estimation for Seals in Transmission of Vehicle

A temperature field model based on energy flow analysis of wet clutch sliding interface

Four-Parameter Real-Time Thermal Model for Dry DCTs

Investigation of thermal behavior of a novel multi-conical friction pair during wet clutch's engagement based on finite difference method

Adaptive torque control of wet dual clutch based on dynamic friction coefficient estimation

A Simulation Study of the Temperature Field of A DCT Under the Frequent Shifting Condition

Temperature Field Characteristics of Limited Slip Clutch under Various Condition Parameters

Experimental measurement of a multi-pole magnetorheological fluid clutch under air cooling

Simulation Of Wet-Clutch Short-Time Load End Speed Control System On Amesim

Dynamic performance prediction and experimental analysis of wet clutch actuator considering thermal flow characteristics

Study on dynamic characteristics variation mechanism of wet-clutches during the filling phase considering temperature and rotational speed of the oil