Abstract:The heat partition coefficient between two finite thickness contact discs during long-time sliding is studied with a coupled finite element method. Results show that the heat partition coefficient varies from its initial value to another steady state value rapidly instead of being a constant all the time. An analytical solution of the temperature field under invariant heat flux input is deduced, which tells that there exists a unique critical thickness ratio between the contact discs that keeps the heat partition coefficient a constant. An equivalent method for single-material contact bodies is proposed that is capable of calculating the steady state heat partition coefficient for any thickness ratio. It reveals that the steady state heat partition coefficient only has relationship with the mass density and the heat capacity of the materials and the thickness ratio. Based on this method, a two-step material equivalent method is further proposed for the contact discs that have friction linings on them. The solution shows that the steady state heat partition coefficient in this situation is also only determined by the material properties and the layer thicknesses. A test bench of multi-disc clutch is set up and a series of sliding experiments are conducted to validate the proposed equivalent methods and solutions of steady state heat partition coefficient. The measured experimental temperature variations show that the temperature level of the separator disc in the clutch is overestimated with the constant heat partition coefficient of semi-infinite model, while it is close to those calculated results with steady state heat partition coefficient. Therefore, the temperature fields of the contact discs during long-time sliding with constant speed can be figured out efficiently using the steady state heat partition coefficient with only small error, and these equivalent methods benefit the multi-disc clutch design and temperature estimation in practical applications.

Finite Element Analysis for Temperature Field of Clutches Based on B-spline Wavelet

Modeling Heat Transfer During Friction Stir Welding Using a Meshless Particle Method

Numerical and Experimental Research on Engagement Process of Wet Multi-Plate Friction Clutches with Groove Consideration

Finite Element Analysis of Temperature Field of Clutch in Tunnel Boring Machine

Finite Element Analysis of Spindle Thermal Character Based on Thermal Contact Resistance

Prediction of the Temperature on AMT Clutch-disc Surface Based on LS-SVM

Theoretical Analysis of Temperature Field in Surface Grinding with Cup Wheel

Finite-Element Analysis of Aerostatic Lubrication with Porous Restrictors Based on Hypermesh

FINITE ELEMENT ANALYSIS OF THE THERMAL BEHAVIOUR OF SINGLE-DISC CLUTCHES DURING REPEATED ENGAGEMENTS

A temperature field model based on energy flow analysis of wet clutch sliding interface

Analytical Model and Material Equivalent Methods for Steady State Heat Partition Coefficient Between Two Contact Discs in Multi-Disc Clutch

Investigation of thermal behavior of a novel multi-conical friction pair during wet clutch's engagement based on finite difference method

Influence upon temperature field distribution with straight grooves parameters of clutch friction disk

The Application of the Wavelet Finite Element Method on the Temperature Calculation of Ceramic Coating Diesel Engine Piston

Study on Spline Stress of Separator Plates in a Wet Multi-Plate Clutch

Thermoelastic coupling vibration and stability analysis of rotating circular plate in friction clutch

A Spline Finite Point Method for Nonlinear Bending Analysis of FG Plates in Thermal Environments Based on a Locking-free Thin/Thick Plate Theory

A quantitative method of calculating transient nonlinear heat partition coefficient between clutch friction discs with deep learning

Heat exchange based finite element analysis of thermal errors in machine spindles

A three-dimensional B-spline wavelet finite element method for structural vibration analysis

Temperature Analysis of Wet Clutch' Friction Pair Considering Axial Pressure Attenuation Effect