Abstract:The temperature field of limited slip clutch (LSC) seriously interferes with torque transmission. In this paper, the attribute of dynamic partition of slip heat flux is considered. A calculation model of temperature field is also established by combining the proposed new method of fluid-solid equivalent convective heat transfer. The simulation and experiment of different relative speed, lubricant flow, and temperature are carried out. Furthermore, the comprehensive evaluation index of average temperature growth ratio and maximum radial temperature difference is proposed. The results show that the deviations of temperature rising rate and average temperature are not more than 0.2 °C/s and 6 °C, respectively. Heat flux partition value of separator plate increases approximately proportionally with relative speed. Changing relative speed from 40 r/min to 80 r/min, average temperature growth rate and maximum radial temperature difference of separator plate increase by 0.35 °C/s and 2.08 °C, respectively. On the contrary, increasing lubricant flow or reducing lubricant temperature weakens actual heat flux input of clutch. From 3 L/min to 10.5 L/min about lubricant flow, the average temperature growth rate and maximum radial temperature difference caused by higher relative speed are reduced by 0.32 and 2.71 °C, respectively. However, when lubricant temperature is adjusted from 65 °C to 30 °C, average temperature growth rate is reduced by 0.51 and the variation of maximum radial temperature difference does not exceed 0.32 °C. The research can accurately simulate actual energy flow at friction pair interface and assist in exploring the influence of condition parameters on temperature field.

Prediction of the Temperature on AMT Clutch-disc Surface Based on LS-SVM

Analysis and Modeling for Electro-pneumatic AMT System

Experimental and Theoretical Analysis of the Drag Torque in Wet Clutches

Simulation and Experiment on Dynamic Engagement Characteristics of Wet Clutch

Validation of an analytical model for grinding temperatures in surface grinding by cup wheel with numerical and experimental results

Experimental prediction model for full life friction performance of wet clutch via attention-based LSTM network

Numerical and Experimental Research on Engagement Process of Wet Multi-Plate Friction Clutches with Groove Consideration

Tribo-thermal simulation study of AMT dry clutch assembly under the continuous sliding grinding condition

Finite Element Analysis for Temperature Field of Clutches Based on B-spline Wavelet

Thermal Error Prediction of Numerical Control Machine Tools Based on Least Squares Support Vector Machines

Transient temperature characteristics of friction clutch disc considering thermal contact conductance under sliding conditions

Life Cycle Prediction and Evaluation of Clutch Friction Plate Considering Wear Models and Thermal Stress

Temperature Field Characteristics of Limited Slip Clutch under Various Condition Parameters

A Model-Based Temperature Estimation Method and Experimental Verification for 4WD Vehicle Transfer Case Clutch

A temperature field model based on energy flow analysis of wet clutch sliding interface

A quantitative method of calculating transient nonlinear heat partition coefficient between clutch friction discs with deep learning

Investigation of thermal behavior of a novel multi-conical friction pair during wet clutch's engagement based on finite difference method

Dynamic performance prediction and experimental analysis of wet clutch actuator considering thermal flow characteristics

Temperature Analysis of Wet Clutch' Friction Pair Considering Axial Pressure Attenuation Effect

Prediction of maximum temperature of fluid-lubricated bearing based on machine learning algorithm

Influence upon temperature field distribution with straight grooves parameters of clutch friction disk