Abstract:In order to solve the problems of the shuffle caused by internal and external excitation and the difficulty in obtaining the real-time accurate engine torque during the parallel mode operation of hybrid electric vehicles, a dynamic coordination control strategy for suppressing the jitter of hybrid electric vehicles based on the closed-loop control of engine speed was proposed. The engine torque filtering control method based on the slope limit was adopted to limit the rate of change of the engine torque and reduce the impact caused by the sudden change of the engine torque; the engine speed closed-loop control method was used to take the motor speed which is easy to be measured accurately in real time as the feedback control variable, which solved the problem of the real-time accurate estimation of the engine torque online. In parallel mode, the motor torque accounts for a small proportion because the torque distribution method gives priority to the engine. When the amplitude of the engine speed is greater than that of the motor speed and the phase of the engine speed is different from that of the motor speed, if the motor damping control is still adopted, the engine speed jitter cannot be eliminated due to the phase difference. In order to suppress the engine torsional vibration in parallel mode and ensure the good acceleration ability of the system, an active damping control strategy based on the engine speed control was proposed. Kalman filter algorithm is used to calculate the target engine speed signal, and the difference between the target speed and the actual speed is processed by a series of low pass filter, double derivative filter and two-stage series lead correction, forming a compensation torque component and superimposed on the engine torque to suppress the speed fluctuation, thereby increasing the system damping and enabling the system to achieve stable acceleration. In this paper, two-stage series lead phase filter is selected to increase the lead phase in the control system, so as to improve the damping of the transmission system with insufficient natural damping in a closed-loop sense. The center frequency of the filter is set as the natural frequency of the powertrain. A simulation platform is set up by using Matlab/Simulink. The simulation results show that the proposed dynamic coordination control strategy can reduce the fluctuation of the engine speed and vehicle speed, and effectively improve the ride comfort of the hybrid electric vehicle.

Study on Dynamic Torque PID Control for Automobile Diaphragm Spring Clutch Based on Kalman Filter

Single neuron adaptive PID control for hydro-viscous drive clutch

Compound Sliding Mode Motion Trajectory Tracking Control of an Electro-Pneumatic Clutch Actuator While Maximizing Its Stiffness

Study on the Vehicle Controller of Hybrid Electric Vehicle Based on Fuzzy Logic

Parametric Analysis of the Drag Torque Model of Wet Multi-Plate Friction Clutch with Groove Consideration

Simultaneous Control of Motion and Maximized Stiffness for an Electro-Pneumatic Clutch Actuator Based on Pressure Observers

Hierarchical Control of Starting Process for Wet Dual Clutch Transmission Based on Direct-Drive Pump-Controlled Hydraulic Actuator

Dynamic coordinated control strategy of a dual-motor hybrid electric vehicle based on clutch friction torque observer

Optimal Trajectory Planning of Motor Torque and Clutch Slip Speed for Gear Shift of a Two-Speed Electric Vehicle

The Design of Low Cost Valve-and-pump Compounded Pressure Control System for the Hydro Viscous Clutch

Simultaneous Estimation and Receding Horizon Sliding Control of Dog Clutch Coupling with Backlash for Rear Electrical Drivelines

A Modified Predictive Functional Control with Sliding Mode Observer for Automated Dry Clutch Control of Vehicle

Dynamic modeling, clutch parameter adaptation, and control of automatic transmission for tracked vehicles

Estimation of the clutch pressure basing on reduced order model of the hydraulic actuator system

Development and evaluation of a magnetorheological fluid-based clutch with hybrid excitation

Design and Implementation of Clutch Control for Automotive Transmissions Using Terminal-Sliding-Mode Control and Uncertainty Observer

Adaptive torque control of wet dual clutch based on dynamic friction coefficient estimation

Improved Decoupling Control for a Powershift Automatic Mechanical Transmission Employing a Model-Based PID Parameter Autotuning Method

Position-based impedance torque control for automatic clutch with robust predefined-time stability guarantee

A Dynamic Coordinated Control Method for Parallel Hybrid Electric Vehicle Based on Model-matching-control

Research on the Anti-Shuffle Control for Hybrid Electric Vehicles in the Parallel Mode