Abstract:This paper defines a control method for shift torque exchange stage and a torque distribution control method for speed regulation stage. In the torque exchange stage, the torque distribution problem of active and passive clutches considers the injection of sine curve for local correction, which can solve the fish belly problem of hydraulic response (i.e. the hydraulic response is slow at the beginning and the hydraulic response is fast at the end). In the speed regulation stage, the target speed gradient profile is determined according to different shift types. The determination of the target speed gradient profile integrates different driving modes, throttle, P2 energy and clutch temperature. In the speed regulation stage, the torque distribution control problem of the speed phase including which actuator (P1, engine, C0 clutch) is used preferentially for speed regulation. a) If the speed regulation torque assigned to the input shaft exceeds the input shaft intervention torque capacity, then the excess part is assigned to the clutch for speed regulation. b) If the speed regulation torque assigned to the input shaft is less than the input shaft intervention torque capacity and the speed regulation torque assigned to the input shaft is less than the motor 2 speed regulation torque intervention capacity, the speed regulation torque is assigned preferentially to P2 for lifting torque. The total P2 request torque for P2 is equal to the sum of the speed regulation torque intervention of P2 and the P2 torque requested by ECM because of the fast response and high precision of the motor. c) If the governing torque assigned to the input shaft is less than the input shaft intervention torque capability and the governing torque assigned to the input shaft is greater than the motor 2 governing torque intervention capability, the excess is assigned to the engine. The total engine requested torque is equal to the sum of the engine governing torque intervention and the engine torque requested by the ECM.

Hierarchical Control of Starting Process for Wet Dual Clutch Transmission Based on Direct-Drive Pump-Controlled Hydraulic Actuator

Single neuron adaptive PID control for hydro-viscous drive clutch

Compound Sliding Mode Motion Trajectory Tracking Control of an Electro-Pneumatic Clutch Actuator While Maximizing Its Stiffness

Nonlinear Control of Direct-Drive Pump-Controlled Clutch Actuator in Consideration of Pump Efficiency Map

The Design of Low Cost Valve-and-pump Compounded Pressure Control System for the Hydro Viscous Clutch

Clutch Pressure Control Based on PWM High Speed On-Off Valve

Simulation Of Wet-Clutch Short-Time Load End Speed Control System On Amesim

Hierarchical Control of Dry Clutch for Engine-Start Process in a Parallel Hybrid Electric Vehicle

Simultaneous Control of Motion and Maximized Stiffness for an Electro-Pneumatic Clutch Actuator Based on Pressure Observers

A New Control Strategy of the Filling Phase for Wet Dual Clutch Transmission

MAP Control of Starting Clutch Based on DMC-PID Cascade Algorithm

Design and Efficiency Analysis of Wet Dual Clutch Transmission Decentralise D Pump-Controlle D Hydraulic System

Adaptive Gearshift Control for Dual Clutch Transmissions Based on Hybrid Physical and Data Driven Modeling

Simulation study on starting of dual clutch transmission for tracked vehicles

Research on the Optimal Control of Working Oil Pressure of DCT Clutch Based on Linear Quadratics Form

Closed-loop Slip Control of Clutches in Hydraulic Automatic Transmission

On Control Strategy of Automatic Transmission Starting Process.

Design and Implementation of Clutch Control for Automotive Transmissions Using Terminal-Sliding-Mode Control and Uncertainty Observer

Wet Dual Clutch Launching Adaptive Control Considering Service Time

Optimal Robust Control of Shifting Process for Hybrid Electric Car with Dry Dual Clutch Transmission

Motor Control During Gearshift Phase to Reduce the Oscillation in Dual Hybrid Vehicles