Abstract:This paper presents a detailed investigation of the dry clutch engagement process, and vehicle start-up judder phenomenon that could result in the deterioration of vehicle ride comfort. Elasto-plastic friction model is elaborated through the slider-pulley system, which shows some friction characteristics such as presliding, stick-slip motion, Stribeck effects, etc., and applied to dry clutch. The axial compression characteristics of three elastic parts, which include diaphragm spring, cushion spring, and link strip have been taken into consideration, and nonlinear relationship between the release bearing travel and the clutch clamp force is also established. The powertrain system model of front-engine and front-wheel-drive vehicle equipped with manual transmission is set up to recreate the start-up judder phenomenon in the numerical simulation and analyze its mechanism. The sudden transfer of the engine torque during the clutch engagement process results in the initial judder, which can be supposed as the step response of system and is initially weakened due to the damping of the powertrain system. Then the judder gradually strengthens and gets in the most severe vibrance when the clutch is about to get in to the fully engaged state, which is related to the frictional characteristics that forms a closed-loop positive feedback system, as well as the frequent state transitions between sliding state and engaged state. The positive slope of Stribeck effect as well as the reduction of absolute value of negative slope can both effectively suppress the start-up judder, and the apparent judder occurs only if the negative slope is outside of a certain range, instead of in all of the range. In addition, the fluctuation of clutch clamp force can aggravate the start-up judder, in which a more chaotic oscillation is emerged.

Wet Dual Clutch Launching Adaptive Control Considering Service Time

Adaptive torque control of wet dual clutch based on dynamic friction coefficient estimation

Compound Sliding Mode Motion Trajectory Tracking Control of an Electro-Pneumatic Clutch Actuator While Maximizing Its Stiffness

Simultaneous Control of Motion and Maximized Stiffness for an Electro-Pneumatic Clutch Actuator Based on Pressure Observers

Hierarchical Control of Starting Process for Wet Dual Clutch Transmission Based on Direct-Drive Pump-Controlled Hydraulic Actuator

Multi-state control strategy of starting for a wet friction clutch via a fuzzy logic algorithm

Simulation Of Wet-Clutch Short-Time Load End Speed Control System On Amesim

Robust engine slipping start control of hybrid electric vehicles with uncertainty in clutch slipping torque and change in driver demand torque

Coordinated Clutch Slip Control for the Engine Start of Vehicles with P2-hybrid Automatic Transmissions

Dynamic coordinated control strategy of a dual-motor hybrid electric vehicle based on clutch friction torque observer

Engagement Control of Automated Clutch for Vehicle Launching Considering the Instantaneous Changes of Driver's Intention

Design and Implementation of Clutch Control for Automotive Transmissions Using Terminal-Sliding-Mode Control and Uncertainty Observer

Multi-objective Optimization of Active Dry Friction Damper-Rotor Systems Based on Predictive Control

Optimal Gear Shift Control of Two-Speed Dual-Clutch Transmission in Electric Vehicle for Smoothness and Friction Loss Reduction

Torque coordinating robust control of shifting process for dry dual clutch transmission equipped in a hybrid car

Simultaneous Estimation and Receding Horizon Sliding Control of Dog Clutch Coupling with Backlash for Rear Electrical Drivelines

Dynamic analysis of vehicle start-up judder based on elasto-plastic friction model and dry clutch maneuvering characteristic

An improved adaptive position tracking strategy for automatic shift actuator with uncertain parameters

A Modified Predictive Functional Control with Sliding Mode Observer for Automated Dry Clutch Control of Vehicle

Adaptive Launching Control Strategy of In-wheel Motor Driven Vehicle

Optimal Torque Control of the Launching Process with AMT Clutch for Heavy-Duty Vehicles