Abstract:Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, Ahead of Print. In this study, a novel TCU control structure and algorithms including also dynamic model of the transmission will perform the gear shifting of automatic transmissions used in tracked military vehicles are designed. In case of inherent wear of the clutches, the clutch parameters are estimated by means of an adaptation algorithm that uses only the information from the transmission input and output speed sensors. These estimated clutch parameters are used in clutch torque calculation is utilized by control algorithms. For the clutch speed control in the inertia phase, a PID control structure with a negative feedforward term that cancels the nonlinearities of the system is proposed. The feedforward term utilizes the estimated wear clutch coefficients in the calculation of friction coefficients. The parameters of the PID controller are optimized by a genetic algorithm. The designed all structure are firstly tested on a MATLAB/Simulink power train simulation model, and then tested using a unique transmission on a transmission dynamometer test bench to examine its suitability for real transmission scenarios. The performances of proposed PID control and a backstepping nonlinear controller that we constructed for the tracked vehicles are compared with and without clutch wear. Maximum tracking error is decreased by 98% with proposed adaptive PID control structure with nonlinear feedforward term compare to backstepping controller. In the case of clutch wear, the back-stepping control exists in the literature has been found to result in oscillation. By updating the estimated friction coefficient from adaptation algorithm, in the backstepping controller, it is concluded that these oscillations can be eliminated. Additionally, on-off solenoid valves, are widely used, are known to cause torque interruptions and jerks during gear shifting. It has been observed the control structure presented in this study reduced the jerks by one quarter.

Optimal Trajectory Planning of Motor Torque and Clutch Slip Speed for Gear Shift of a Two-Speed Electric Vehicle

Compound Sliding Mode Motion Trajectory Tracking Control of an Electro-Pneumatic Clutch Actuator While Maximizing Its Stiffness

Optimal Gear Shift Control of Two-Speed Dual-Clutch Transmission in Electric Vehicle for Smoothness and Friction Loss Reduction

Shifting Control of Automatic Mechanical Transmissions for Electric Vehicles Based on Optimal Control Theory

Motor Control During Gearshift Phase to Reduce the Oscillation in Dual Hybrid Vehicles

Control Algorithm for a Seamless Shifting 2-Speed Transmission Based on the Optimal Trajectory

Shift Modeling Based on Long Short-Term Memory for Manual Transmission System and Shift Process Improvement by Using Bionic Optimization

Modeling and Analysis of Gear-Shifting Process of Motor-Transmission Coupled Drive System

Performance Comparison of Pure Electric Vehicles with Two-Speed Transmission and Adaptive Gear Shifting Strategy Design

Improved Decoupling Control for a Powershift Automatic Mechanical Transmission Employing a Model-Based PID Parameter Autotuning Method

Experimental Investigation and Control of Driveline Torsional Vibrations during Clutch-to-Clutch Shifts of Electrified Vehicles

Design and Control of A Novel Two-Speed Uninterrupted Mechanical Transmission for Electric Vehicles

Gear-shifting control of non-synchronizer electric-driven mechanical transmission with active angle alignment

Parameter Optimization of Dual Clutch Transmission for an Axle-split Hybrid Electric Vehicle

Efficient Mode Transition Control for Parallel Hybrid Electric Vehicle with Adaptive Dual-Loop Control Framework

Time-Optimal Coordination Control for the Gear-Shifting Process in Electric-Driven Mechanical Transmission (dog Clutch) Without Impacts

Dynamic modeling, clutch parameter adaptation, and control of automatic transmission for tracked vehicles

Control strategy of automated manual transmission based on active synchronisation of driving motor in electric bus

Optimization of torque converter slip speed at launching conditions

Optimization of straight-line driving torque vectoring for energy-efficient operation of electric vehicles with multiple motors and disconnect clutches

The control algorithm of active synchronization of motor in shifting process for electric vehicles