Abstract:The influence of different wind speeds and sealed curing time on early-age shrinkage of cement paste was investigated. The 72-h early-age total shrinkage of cement paste after sealed curing for 0 h, 3 h, 6 h, 9 h, 12 h, and 24 h starting from the initial setting time under different wind speeds was studied. Water loss, autogenous shrinkage, tensile strength, pore size distribution (PSD) and hydration degree were measured. Elastic modulus, cracking strain, and radius of the pores where the meniscus forms were calculated based on the data obtained. For mixtures that did not undergo sealed curing, the wind speed could considerably increase the drying shrinkage and total shrinkage of the cement paste. The wind speed also reduced the early tensile strength, hydration degree, and elastic modulus of the cement paste. Within 1 day, the cracking strain was reduced by wind speed. According to the experimental data, a fitting formula for the early total shrinkage of cement paste is proposed, and the wind speed influencing factor beta(w) is also proposed for the first time. Considering the PSD and water loss to study the mechanism of early drying shrinkage of cement paste, we found that there is a good correlation between r(s) and drying shrinkage. The exponential formula is given between r(s) and drying shrinkage. For mixtures with sealed curing, the total shrinkage and water loss decreased with increasing sealed curing time. However, the effects of water loss at different stages on drying shrinkage were different. Water evaporation in the early stage led to more drying shrinkage than water evaporation in the later stage. Sealed curing also weakened the increasing effect of wind speed on total shrinkage, so that at the same wind speed, the shrinkage increment was considerably reduced. After analysis and comparison, it was found that it is economical and reasonable to adopt sealed curing for 6 or 9 h, which can effectively decrease the early total shrinkage and improve the cracking strain of the cement paste in the wind environment. (C) 2020 Elsevier Ltd. All rights reserved.

Investigation of early drying shrinkage of ultrahigh-performance concrete under windy conditions

Powder Gradation Effect on the Fresh, Mechanical, and Early-Age Shrinkage Properties of UHPC

Will Wind Always Boost Early‐age Shrinkage of Cement Paste?

Identification of Indexes That Could Reflect Early Drying Shrinkage of High Strength Concrete with Minerals

Early-age Shrinkage Behavior of Cement-Fly Ash Paste under Wind Speeds: A Study Using BSE-IA and MIP Techniques

Effect of Different Wind Speeds and Sealed Curing Time on Early-Age Shrinkage of Cement Paste

Plastic and early-age shrinkage of ultra-high performance concrete (UHPC): Experimental study of the effect of water to binder ratios, silica fume dosages under controlled curing conditions

Shrinkage Mitigation of an Ultra-High Performance Concrete Submitted to Various Mixing and Curing Conditions

Establishment of Drying Shrinkage Deformation Model and Ingredient Correlation Analysis of Ultra-high Performance Concrete

Mechanical and Drying Shrinkage Performance Study of Ultra-High-Performance Concrete Prepared from Titanium Slag under Different Curing Conditions

Effects of Shrinkage Reducing Agent and Expansive Admixture on the Volume Deformation of Ultrahigh Performance Concrete

Autogenous shrinkage prediction models and microstructure of UHPC with single or binary addition of an expansive agent and steel fibers

Drying Shrinkage Behavior of Ultra High Toughness Cementitious Composites and Its Influence on Anti-Cracking Capacity

Stresses Due To Autogenous Shrinkage And Drying Shrinkage In Hsc And Its Evaluation

Shrinkage-induced Warping of UHPC Overlay Cast on Hardened NSC Substrate under Various Conditions

Influence of High Temperature Curing and Surface Humidity on the Tensile Strength of UHPC

Research on shrinkage control technology of lightweight ultra-high performance concrete

Effect of Pre-Wetted Zeolite Sands on the Autogenous Shrinkage and Strength of Ultra-High-Performance Concrete

Early age autogenous shrinkage cracking risk of an ultra-high performance concrete (UHPC) wall: Modelling and experimental results

Effect of Curing Conditions on the Shrinkage of Ultra High-Performance Fiber-Reinforced Concrete

Effect of lightweight sand and shrinkage reducing admixture on structural build-up and mechanical performance of UHPC