Abstract:In this paper, a high-resistivity silicon (HR-Si) interposer integrated with through-silicon via (TSV) electrically grounded coplanar waveguide (CPW) line is presented for 2.5-D/3-D heterogeneous integration of radio frequency (RF) microelectronics devices. In addition, design of TSV interconnection composed of two coaxial ladder-hollow-annular Cu (copper) TSVs of different diameters is utilized to maintain a sufficient freedom for strict standard cleaning to avoid Si resistivity degradation. The formation of the coaxial ladder TSV structure is more beneficial to the subsequent plating process because it reduces the aspect ratio of TSV vias. Hollow-annular Cu TSV is manufactured in order to reduce the problem of mismatch in coefficient of thermal expansion among TSV's constituent materials. A layer of Au (aurum) film is utilized to passivate the exposed Cu surface of Si interposer. Au is widely used in III-V groups' devices because of the good compatibility with photonic integrated circuits, conductivity, and corrosion resistance. HR-Si interposer with TSV grounded CPW line and test structure is fabricated and characterized. With the monitoring test results, it can be found that it changes little in the resistivity of Si substrate, though the whole process, which is a basic requirement for RF performance. RF property test results show that the insertion loss is about -0.20 dB/mm at 10 GHz for the presented TSV grounded CPW line and -0.02 dB per TSV. These test results are better than the traditional design. To verify its applicability to 2.5-D/3-D heterogeneous integration, RF microelectronics die is assembled on TSV interposer and tested, and the test results prove that it works properly.

Verification of 2.5D/3D heterogeneous RF integration of HR-Si interposer

Design and Fabrication of a TR Microsystem in Ka Band with Si-Based 3D Heterogeneous Integration

A 2.5D Integrated L Band Receiver Based on High Resistivity Si Interposer

Design, process, and electrical verification of HR-Si interposer for 3D heterogeneous RF integration

A Compact 2-18Ghz Ultra-Wideband Frequency-conversion T/R Module Based on a 3D Heterogeneous Integrated Process

Fabrication and RF Property Evaluation of High-Resistivity Si Interposer for 2.5-D/3-D Heterogeneous Integration of RF Devices

Three-dimensional circuit integration based on self-synchronized RF-interconnect using capacitive coupling

A Multilayer Dual-Band Coupler Based on Composite Right/left-Handed Folded Substrate Integrated Waveguide

3D Heterogenous Integrated Wideband Switchable Bandpass Filter Bank for Millimeter Wave Applications

Design and Implementation of RF Front-End Module Based on 3D Heterogenous-Integrated Wafer-Level Packaging

Design, Fabrication, and Radio Frequency Property Evaluation of a Through-Glass-via Interposer for 2.5D Radio Frequency Integration

Implementation of a 2-D Reconfigurable Fresnel-Zone-Plate Antenna

Design of an indoor channel measurement system

Process Development of Thick Si Interposer for 2.5d Integration of Rf Mems Devices

Design for the reader of UHF Radio frequency identification

Design and Experimentally Verification of a Vertical Coaxial Transmission Structure in High resistivity Si Interposer

Thermal Resistance Analysis for a High Power 3D Integrated RF Module Based on TSV Interposer

Design, Fabrication And Characterization Of A Q-Band Patch Antenna Integrated On Stacked Interposers

Analysis And Simulation For Rf Interconnect

Vertical Interconnection Technology for RF MicroSystem Packaging