Abstract:In order to reduce the manufacturing cost of foamed ceramics and expand the application scope of industrial solid waste, in this study, a new type of environment-friendly foamed ceramics was prepared using direct high-temperature foaming with waste silicomanganese slag (SMS) and fly ash (FA) as raw materials and silicon carbide (SiC) as a foaming agent. The influence of SMS content, SiC content, and sintering temperature on the characteristics and microstructure of the specimen were explored. More concretely, the compressive strength, pore morphology, bulk density, and crystalline composition of the foamed ceramics were discussed. The foaming mechanism was also further analyzed. The results showed that including 20% SMS significantly reduced the melt's viscosity and stimulated bubble expansion. This, in turn, facilitated the creation of a porous structure. Moreover, it was noted that samples containing 20% SMS exhibited an anorthite phase when sintered at 1110 °C, resulting in enhanced compressive strength. The bulk density and compressive strength of the foamed ceramics decreased with an increase in the sintering temperature and SiC content. This trend was primarily attributed to the higher total porosity and the insufficient support of the pore wall to the matrix. The best all-around performance was achieved with 20 wt% SMS, 80 wt% FA as raw material, SiC addition of 1.0 wt%, and a sintering temperature of 1100 °C. Under these conditions, the compressive strength, bulk density, and total porosity of the foamed ceramics were 8.09 MPa, 0.57 g/cm3, and 71.04%, respectively. Taken together, the outstanding porous structure and mechanical properties of this foamed ceramic make it suitable for use as insulation or for building partition materials.

Fabrication of SiC Foam Ceramics at a Low Sintering Temperature by Adding Fly Ash

Effect of Alkaline Oxides (cao and MgO) on the Mechanical Properties of SiC-based Foam Ceramics

Recycling of Silicomanganese Slag and Fly Ash for Preparation of Environment-Friendly Foamed Ceramics

Preparation of ceramic foams from ceramic tile polishing waste and fly ash without added foaming agent

Preparation of high–strength closed–pore foamed ceramics from desalted sea sand at temperatures below 1000 °C

Fabrication of SiCN(O) Aerogel Composites with Low Thermal Conductivity by Wrapping Mesoporous Aerogel Structures over Mullite Fibers

Novel Mullite Ceramic Foams with High Porosity and Strength Using Only Fly Ash Hollow Spheres As Raw Material

Fabrication, Structure and Properties of Porous SiC Ceramics with High Porosity and High Strength

Preparation and Numerical Modelling of Ceramic Foam Insulation for Energy Saving in Buildings

A novel sintering additive system for porous mullite-bonded SiC ceramics: High mechanical performance with controllable pore structure

Preparation of High-strength ceramsite from municipal solid waste incineration fly ash and clay based on CaO-SiO2-Al2O3 system

Preparation of Porous Si2N2O/SiC Ceramics by Microwave Sintering

Ultralight and Mechanically Robust SiC Foams with Interconnected Cellular Architecture

Preparation and characterization of lightweight SiC frameworks by connecting SiC fibers with SiC joints

Preparation of SiC reticulated porous ceramics with high strength and increased efficient filtration via fly ash addition

Silicon carbide ceramics manufactured by digital light processing and low temperature sintering

Influence of additive contents on the properties of SiC ceramic membranes and their performance in oil‐water separation

Flash Sintering of Silicon Carbide at Room Temperature

Properties and performance of cordierite-bonded porous silicon carbide membrane prepared using waste fly ash and other oxide additives

Development of a Loose Powder Sintering Method for the Preparation of Porous Ceramic from Municipal Solid Waste Incineration Fly Ash

In-situ synthesis of Fe Si phases and their effects on the properties of SiC porous ceramics