Abstract:In order to reduce the manufacturing cost of foamed ceramics and expand the application scope of industrial solid waste, in this study, a new type of environment-friendly foamed ceramics was prepared using direct high-temperature foaming with waste silicomanganese slag (SMS) and fly ash (FA) as raw materials and silicon carbide (SiC) as a foaming agent. The influence of SMS content, SiC content, and sintering temperature on the characteristics and microstructure of the specimen were explored. More concretely, the compressive strength, pore morphology, bulk density, and crystalline composition of the foamed ceramics were discussed. The foaming mechanism was also further analyzed. The results showed that including 20% SMS significantly reduced the melt's viscosity and stimulated bubble expansion. This, in turn, facilitated the creation of a porous structure. Moreover, it was noted that samples containing 20% SMS exhibited an anorthite phase when sintered at 1110 °C, resulting in enhanced compressive strength. The bulk density and compressive strength of the foamed ceramics decreased with an increase in the sintering temperature and SiC content. This trend was primarily attributed to the higher total porosity and the insufficient support of the pore wall to the matrix. The best all-around performance was achieved with 20 wt% SMS, 80 wt% FA as raw material, SiC addition of 1.0 wt%, and a sintering temperature of 1100 °C. Under these conditions, the compressive strength, bulk density, and total porosity of the foamed ceramics were 8.09 MPa, 0.57 g/cm3, and 71.04%, respectively. Taken together, the outstanding porous structure and mechanical properties of this foamed ceramic make it suitable for use as insulation or for building partition materials.

Preparation and Numerical Modelling of Ceramic Foam Insulation for Energy Saving in Buildings

Preparation of Glass Ceramic Foams for Thermal Insulation Applications from Coal Fly Ash and Waste Glass

Preparation and Modeling of Energy-Saving Building Materials by Using Industrial Solid Waste

Preparation and characterization of ceramic foams mainly containing extracted titanium residues and silica tailings

Integrated utilization of high alumina fly ash for synthesis of foam glass ceramic

Integrated Utilization of Fly Ash and Waste Glass for Synthesis of Foam/dense Bi-Layered Insulation Ceramic Tile

Preparation of foam ceramics from solid wastes: a study on the relationship between firing regime and properties by grey system theory

Recycling of Silicomanganese Slag and Fly Ash for Preparation of Environment-Friendly Foamed Ceramics

Strength and thermal insulation properties of foam-formed ceramic fiber paper with different reinforcement methods

Reuse of mineral wool waste and recycled glass in ceramic foams

Synthesis, characterization and modeling of new building insulation material using ceramic polishing waste residue

Tailoring the Thermal and Mechanical Properties of Lightweight Cement-Based Composites by Macro and Micro Fillers

RESEARCH ON HIGH-EFFICIENT THERMAL INSULATION CERAMIC MATERIALS

Preparation of Porous Thermal Insulation Material Using Fly Ash

Fabrication of Mullite-Corundum Foamed Ceramics for Thermal Insulation and Effect of Micro-Pore-foaming Agent on Their Properties

Fabrication of SiC Foam Ceramics at a Low Sintering Temperature by Adding Fly Ash

Preparation of ceramic foams from ceramic tile polishing waste and fly ash without added foaming agent

Polypropylene fiber reinforced alkali-activated ultra-light foam insulation material: Performance study and mechanism analysis

Optimization of coal-based solid waste ceramsite foam concrete mix proportions and performance study

Effect of Sic on Microstructures and Properties of Clay Foam Ceramics

Thermal Insulation and Moisture Resistance of High‐Performance Silicon Aerogel Composite Foam Ceramic and Foam Glass