Abstract:Biomass fast pyrolysis fluidized bed reactor is regarded as one of the most promising technologies for high value utilization of biomass. In this work, one two-dimensional fluidized bed reactor model was established, coupling with multiphase CFD simulation method and pyrolysis reaction kinetics, and further verified by the experimental data. This work mainly investigated the effects of biomass inlet and nitrogen inlet modes on multi-process characteristics, such as flow behavior, heat transfer and pyrolysis reaction. The synergistic effects between the two inlet modes were further explored and thus would affect the three-phase pyrolysis product distribution. The results showed that the spatial particle distribution and temperature distribution in the dense phase zone were becoming more uniform and the tar yield increased when the biomass inlet mode changed from single nozzle to double nozzles jetting opposite. Besides, when the nitrogen nozzle number was set as one and the auxiliary gas velocity was set as 0.15 m/s, much larger local circulation formed in the dense phase zone, meanwhile the particle volume fraction and temperature became more evenly distributed, which was conducive to the biomass pyrolysis process. The nitrogen inlet mode was found to show a greater impact on the tar yield compared to the biomass inlet mode. For single gas inlet mode, one biomass nozzle should be preferred for lower auxiliary gas velocity and the opposite double nozzle would be better for higher auxiliary gas velocity. The synergistic effects between biomass and nitrogen inlet modes were further summarized, which were found to have a positive impact on the biomass pyrolysis reaction characteristics. Based on the above conclusions, this work could provide a feasible theoretical guidance for designing fluidized bed pyrolysis reactor and optimizing the biomass pyrolysis process.

CFD Simulation of an Industrial MTO Fluidized Bed by Coupling a Population Balance Model of Coke Content

Simulation of multi-fluidized-bed in series for methanol to olefins

Simulation of Fluidized Bed Reactor for Methanol to Olefins(MTO)Process

Multi-Scale Coupling Model Involving Bed and Catalyst Particle for MTP Reactor Simulation

A Seven Lumped Kinetic Model for Industrial Catalyst in DMTO Process

Experimental and Numerical Study of Solids Concentration Distribution in Transition Section of Turbulent Fluidized Bed

Modeling of Molecular Weight and Copolymer Composition Distributions for Ethylene‐propylene Solution Copolymerization

CFD simulation of cross flow in multi-tubular fixed-bed reactor of industrial level

Numerical simulation of commercial MTO fluidized bed reactor with a coarse-grained discrete particle method — EMMS–DPM

Kinetic and Regenerator Modeling of the Coke Combustion in the Moving Bed MTP Process

Simulation and Analysis of the Regeneration Process of Methanol to Propylene

Prediction of Bubble Fluidisation During Chemical Looping Combustion Using CFD Simulation

Multi-Scale Simulation of Biomass Gasification in Fluidized Beds

CFD-DEM Study on the Synergistic Effect of Coke Consumption and Particle Dynamics in the Blast Furnace Raceway

CFD Modelling of the Co-Gasification of Biomass and Coal Particles in Fluidised Beds

Numerical investigation of the oxy-fuel combustion in the fluidized bed using macroscopic model supported by CFD-DDPM

Optimization of methane catalytic decomposition in a fluidized bed reactor: A computational approach

Numerical Simulation and Multi-Process Coupling Analysis for Biomass Pyrolysis Fluidized Bed Reactor Based on Synergistic Effects Between Biomass and Nitrogen Inlet Modes

Three-dimensional CFD simulation of pattern formation in a shallow packed-bed reactor for oxidative coupling of methane

Computational Fluid Dynamics Simulation of a High-Throughput Catalytic Fixed-Bed Reactor for Total Oxidation of Methane

Modeling of Oxidative Coupling of Methane for Manufacture of Olefins—Part I: CFD Simulations