Abstract:Multi-purpose Time Projection Chamber (MTPC) at the Back-n white neutron source of China Spallation Neutron Source (CSNS) is aimed at the measurements of neutron-induced light charged particles or fission particles and neutron resonance radiography. The prototype MTPC is completed as a verification version with 1519 anode channels. A flexible integrated waveform digitizing front-end electronics based on off-the-shelf components was designed to read out anode signals. The front-end electronics are divided into pre-amplifier module (PAM) and analog to digital module (ADM). PAM integrates the anode charge signals and converts them into differential signals. ADM performs analog waveform digitization, digital filtering, online data processing, and packaging. PAM is connected to ADM via a flexible printed circuit (FPC) and the PAM can be replaced according to different requirements of detectors. When digitizing up to 64 channels at 40 MHz, the power consumption is around 140 mW per channel. The performance of the front-end electronics has been tested in the lab. The integral nonlinearity (INL) is less than 0.35% with a 2.8 pC dynamic range, and the average equivalent noise charge without any input load is around 0.76 fC and the maximum is less than 1.3 fC. The readout electronics has been performed a joint test with the prototype MTPC. By analyzing collected anode signals, the 3D-track of neutron-induced light-charged particles was successfully reconstructed. These results indicate that the front-end electronics works well and can satisfy the requirements of the prototype MTPC.

Design of an FPGA Based TDC Readout Electronics for Prototype Mars Ion and Neutral Particle Analyzer

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

A Prototype Design of the Readout Electronics of MRPC Detectors in CEE in HIRFL

Development of a High Resolution TDC for Implementation in Flash-Based and Anti-Fuse FPGAs for Aerospace Application

Development of High Resolution TDC Implemented in Radiation Tolerant FPGAs for Aerospace Application

Readout Electronics of a Prototype Time-of-flightion Composition Analyzer for Space Plasma

Design and Realization of China Tianwen-1 Energetic Particle Analyzer

Design of 32-channel TDC Based on Single FPGA for μSR Spectrometer at CSNS

Design of a Prototype Readout Electronics for a Low-energy Ion Spectrometer in Near-earth Space

A High-Density Time-to-Digital Converter Prototype Module for BES III End-Cap TOF Upgrade

Readout Electronics Prototype of TOF Detectors in CEE of HIRFL

Development of the Front-End Electronics for PandaX-III Prototype TPC

An Analogue Front-End ASIC Prototype Designed For PMT Signal Readout

Design of Prototype Front-end Digital Module for Direct Dark Matter Detection based on LAr

Prototype Front End Electronics of TO Detector in the External Experiment of CSR in HIRFL

A Simple Smart Time-to-digital Convertor Based on Vernier Method for a High Resolution LYSO MicroPET

Design of Waveform Digitizing Front-end Electronics for a Prototype Multi-purpose TPC at CSNS Back-n

Prototype Design of the Time Measurement Circuit for SiPM-based T0 Detector of CEE

FPGA Based Pico-second Time Measurement System for a DIRC-like TOF Detector

The design of a time-interleaved analog-digital conversion modulator based on FPGA-TDC for PET application

Front-End Electronics Design Based on Vernier Method for A High Resolution Micropet