Abstract:High precision time-of-flight (TOF) measurements in modern high-energy physics experiments have often a high demand to measure both pulse timing and pulse width at the same time. The pulse width from such TOF detectors can be as narrow as 1 ns, which poses great challenges to current design of time-to-digital converters (TDCs) based on field programmable gate array (FPGA). In this paper, we propose a novel FPGA-based TDC design which can measure nuclear signals with extremely narrow pulse width outputting timestamps for both the rising edge and falling edge simultaneously. The discriminated digital signal with both timings from the rising edge and falling edge is directly transmitted along the tapped-delay-line (TDL) of the TDC. Relying on the proposed powerful and efficient encoding logic, the two timestamps are precisely extracted out from the TDL status in one time of measurement. The TDC measurement dead time is only two system clock cycle, and the minimum measurable pulse width is only limited by the performance of LVDS receiver of FPGA, which was tested as low as 400 ps in our case of implementing the TDC in a Virtex Ultrascale+ FPGA. Using one TDC channels to measure given pulse width, the RMS precision is evaluated as 3.0 ps. Given the pulse widths ranging from 0.4 ns to 1.5 ns, the measured pulse width by the TDC is highly consistent with the readout values from the oscilloscope. In addition to the excellent performance, compared with previous TDC designs for pulse width measurement, the structure of the proposed TDC is much compact with low logic resource consumption, which is very helpful for multi-channel integration in high-energy physics experiments.

Development of High Resolution TDC Implemented in Radiation Tolerant FPGAs for Aerospace Application

Development of a High Resolution TDC for Implementation in Flash-Based and Anti-Fuse FPGAs for Aerospace Application

Development of radiation tolerance evaluation and measurement system for spaceborne D/A converter

Design and Realization of High Precision Time-interval Measurement Based on FPGA

Low-Cost FPGA TDC with High Resolution and Density

Resources-limited FPGA based-multi-channel TDC system

Low-cost FPGA-based multi-channel TDC with high resolution and density for time-of-flight detectors

High-Resolution, Multi-Channel FPGA-Based Time-to-Digital Converter

Design of Time Digital Converter Based on FPGA

A High Precision Time-to-Digital Converter based on Multi-chain Interpolation with a Low Cost Artix-7 FPGA

A 128-Channel High Performance Time-to-Digital Converter Implemented in an UltraScale FPGA

An FPGA-based, High-Precision, Narrow Pulse Width Measurement Time-to-digital Converter

An FPGA-Based High Precision Pulse Width Measurement Time-to-Digital Converter with Dual-TDL Multiplexer Encoder

A High Resolution Time-to-digital-convertor Based on a Carry-Chain and DSP48E1 Adders in a 28-Nm Field-Programmable-gate-array

A 1.15-Ps Bin Size and 3.5-Ps Single-Shot Precision Time-to-Digital Converter with On-Board Offset Correction in an FPGA

A High-Resolution Tdc Implemented In A 90nm Process Fpga

A High-Throughput Vernier Time-to-Digital Converter on FPGAs with Improved Resolution Using a Bi-Time Interpolation Scheme

A High-Resolution TDC Design Based on Multistep Fine Time Measurement by Utilizing Delay-Adjustable Looped Carry Chains on FPGAs

Design of Readout Interface for Time to Digital Converter Modules

Development of a Low Power and High Integration Readout ASIC for Time Projection Chambers in 65 Nm CMOS

Design of an FPGA Based TDC Readout Electronics for Prototype Mars Ion and Neutral Particle Analyzer